20 Most Recent
Amana AGR5715QDS Gas Kitchen Range - Page 9 Questions & Answers
This morning the clock on
What looks like "5 A6" is actually "Sab" for "Sabbath mode'", believe it or not. Reading and re-reading my owner's manual didn't actually clear up what the heck "Sabbath Mode was, but to cancel it press and hold the CLOCK button for 3 seconds or wait 72 hours and Sabbath Mode will end.
How do I get the
Hello,
The F1 error code means that the computer thinks a button on the touchpad is stuck. Sometimes this can be resolved by making sure the touchpad connector fits tight into the control board. The F1 code can be cleared by pushing CANCEL/OFF. If it returns the touchpad needs to be replaced
GENE
Natural to propane conversion-oven flames too high
Hello,
I know this is a stupid question but in the picture below..did you open the part circled in red and switch the peice in it to the other direction..in other words take it out and flip it upside down as was supposed to be done as part of the conversion process??
This is the pressure regulator where the gas line first connects to
Oven elements arced while replacing
No reset button. What happened is either circuit breaker(mains) tripped or the non resettable high limit thermostat blew or the control board was fried by trying to repair oven while still connected to LIVE POWER
My amana gas range just
Hello,
One possibility is that the circuit breaker has weakened and tripping intermentently for no real reason. To see if that is the case the oven could be plugged into a outlet on a different breaker using a extension cord.
Another potential cause is that any one of the wires in the range has became bare and lost its insulation and touching a peice of metal, shorting out
Good luck in figuring out what is wrong,
Gene
Too much gas in oven
Hello
You have a very dangerous situation. Do not use this machine! Your gas valve and igniter need to be replaced right away!Use a qualified tech please. The gas valve should never open if igniter isn't hot enough. Not an expensive repair.
regards
What is F9
FIND THE WIRING DIGRAM IT WILL TELL YOU WHAT F9 IS IT MAY BE ON BACK OF THE RANGE OR PULL BOTTOM DRAWER OUT SEE IF IT IS ONE SIDE OR THE OTHER
Model number ARG7800E Amana range
Hello, welcome to FixYa.
Based on your description, I`d suggest the hot surface ignitor for the bake burner is likely the problem. Here's what you can try to verify if it's indeed the ignitor...if you're mechanically inclined.
** FIRST unplug the range and turn off the gas to the range before attempting any service...safety first**
Many people overlook the ignitor, especially if it "glows" since that gives the untrained person the impression it works...that is not the case however. (Ignitor may glow but not have sufficient amperage to open valve).
You can ohm it out to test it as follows...at room temp.(approx. 75F) The ignitor should measure between 45 & 400 ohms with an ohm-meter set to Rx1 scale.
You should be able to find one at most brick & mortar appliance parts vendors or on-line depot's such as "repairclinic.com", "searspartsdirect.com" to name a couple.
I would double check with your model number with the part`s professional's.
Hope that help`s. Let me know if I can assist you further or if anything is not clear and good luck.
Thank`s for visiting "fixya" for your repair needs. Please take a moment to rate the assistance you received here and a brief testimony is also appreciated.
Regards,
Macmarkus :)
Not finding what you are looking for?