20 Most Recent
Amana AGR5715QDS Gas Kitchen Range - Page 4 Questions & Answers
HOW TO TIDY UP THAT UNSIGHTLY SILICONE SEAL AROUND YOUR SHOWER BASE OR ANY...
1. BUY A 1/2" TO 1" WIDE WHITE PLASTIC FLAT STRIP ABOUT 2 MM OR 1/8" OR LESS THICK. OR BUY ANY PLASTIC STRIP AND CUT DOWN TO SIZE AS ABOVE.
AT THE BASE OF MY SHOWER WHERE THE BASE UNIT CONNECTS TO THE TILES THERE WAS A UNSIGHTLY SILICONE SEAL.
I GOT A LENGTH OF WALL CABLE CAPPING /WHITE AND CUT IT INTO 1" WIDE FLAT STRIPS OR YOU CAN PURCHASE FLAT PLASTIC STRIPS NORMALLY A COUPLE OF METRES LONG FROM YOUR LOCAL DO IT ALL SUPPLIER , CLEAN AND DRY OLD SEAL USING A HAIR DRYER ,
CUT ONE LENGTH AT A TIME, REMEMBERING TO ANGLE CONNECTING CORNERS, USE FRESH SILICONE TO RUN ALONG WHERE OLD SILICONE IS
PLENTY TO FILL IN GAP , NOW FIT PLASTIC STRIP AT A ANGLE ACROSS TILE AN BASE UNIT ,PUSH IN UNTIL SILICONE STARTS TO SEEP OUT OF EDGES, WIPE WITH A WET CLOTH TO REMOVE ANY SILICONE,
SO YOU END UP WITH A EASY TO CLEAN PLASTIC SEAL ANGLED AS /l AROUND BASE OF SHOWER.
WITH NO SILICONE IN SITE TO DISCOLOR. ALSO WORK TOPS TO TILES CUT SMALL STRIPS SAY 3/8" TO 1/2" WIDE ANY COLOUR. FIT AS ABOVE.
What does p5h code on an amana oven
This is actually the 'PSH' error code which stands for 'Push To Start'. If you do not press the start button within five seconds of a command that will display telling you, that you forgot to PUSH the Start button. If it is randomly showing up by itself you have a defective touch-pad
P5H code on an amana oven
This is actually the 'PSH' error code which stands for 'Push To Start'. If you do not press the start button within five seconds of a command that will display telling you, that you forgot to PUSH the Start button. If it is randomly showing up by itself you have a defective touch-pad
How to remove & replace control board ards802e down draft range
if you open the oven door and look at the bottom of the control panel, you should see about 4 screws. remove those. if you pull the unit away from the cabinet just enough to access 2 screws on each end. Remove those on both ends and panel should lift off. All of the wiring is still connected. MAKE SURE TO SHUT OFF ALL POWER TO UNIT BEFORE BEGINNING REPAIR. DEATH OR INJURY MAY OCCUR. Once panel is free of unit, board is held on with 4 screws. if I can be of further assistance, look for me on 6ya
Not finding what you are looking for?