20 Most Recent
Tomtom GO 910 GPS Receiver - Page 2 Questions & Answers
Down load data from Tom Tom 910
Yes but as a member of the public you will not have the appropriate software or equipment.
Your insurance company will help especially if it helps their claim or the Police will assist you gathering evidence for a prosecution.
Info gained will be speed, time (set by sat gps receiver) not what time you say it is and exact location with 3 square metres and direction of travel.
Hope this helps with your question.
TomTom 910 freeze, long turn on
It is possible that the map data(base) and/or the navigation software is corrupted.
Have you tried running a (fix) disk utility against your (internal or external) storage disk for the GPS ?
For instance, connect the GPS to your PC (Windows), and select (highlight) the (internal) "disk" on the GPS device. Under File - Properties, go to the Tools (tab) and run the "Error-Checking" option.
This utility may fix your data error.
If not, consider doing a restore (from backup) of your GPS disk storage.
Service manual
The black socket with the 15 pins in is damaged/loose. Workshop repair required
TOMTOM ONE -ABOUT 5 YEARS
First, make sure your battery is fully charged. Then try to do a "Reset"
.... by pressing and holding down the ON/OFF button for 5 seconds (or a
lot more) until the device powers on again. Yes, at times, it may take a
minute or more ! of holding that button down.
Hi my tom tom go910
First, check
and make sure your battery is fully charged. Then try to do a "Reset"
.... by pressing and holding down the ON/OFF button for 5 seconds (or a
lot more) until the device powers on again. Yes, at times, it may take a
minute or more ! of holding that button down.
Reset button on 910 ???
Before you reset your 910, first make sure your battery is (well) charged and if you are using an SD card, it is taken out. The reset button is actually a tiny hole at the bottom / base of the unit. Simply use a straightened out paper clip or something similar, insert it into the hole and hold it there for 20 seconds or so, until the device turns off. Then push the ON/OFF button and hold it down for a while ... (5 seconds ... or lots more) until the device powers up again. If you're using an SD card, you can then insert the card (when it is looking for it).
Receiving a no gps signal. please move to an open
Sounds like an antenna problem. Some units have internal antennas and some have external ones that plug into the unit with a small cable. The unit thinks you are still inside and cannot find a satellite to lock on to.
Text message
- Tap Mobile phone in the Main Menu.
- Tap Read/Write Message.
4. Tap the message, and tap delete ( should be along the bottom menu bar )
As the unit uses blue tooth, it may also update changes made by the phone itself. Try deleting messages from your phone to see if it will update the change.
Not finding what you are looking for?