Top 20 LG 42LC2D 42 in. LCD HDTV Questions & Answers

It looks like an electrolytic cap. on the power supply. you may find that the guilty one is bulging on the top.

do you have speaker on each side if so move a way from TV

You can use an HDMI converter for your wii

Lost signal could be several things. Check that you have good connections and that your co-ax cable was made in this century. If you are using over the air look for obstructions like trees or buildings blocking the antenna signal. If you have cable that one is easy, have the cable guy come out and test your signal strength. 98%b of them will do this for free.

Could be start ccts. (main board) or maybe capacitors on the power supply board.

Sounds like power supply is failing

Do a reset to this TV, and then check. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.

Does the menu work?

Be careful using this TV. There is a fault somewhere. No TV should ever do that, cold or not. Replace or repair it

The main power supply regulator section circuit fault. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and time. Even though you can make it right, it will cost around an amount equal to the cost of a new board; including the cost of (spare parts + service charge) More to say, most of the spare parts to it will be difficult to get from open electronic spare part market. This is true to most of the flat panel TV power supply boards; irrespective of its brand and screen size. Search the site by type in the "brand name" to your device; [Exclude the model number], in the "Search box at the top right of the display window of the Homepage" to get gathered related posts.

I would exchange it

Probably power module bad.

Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary. No technician can do more than this, he/she can do anything except.

Sony and HP are enemies nowadays.

Is the TV in some sort of case? Like an entertainment center. Sounds like it's overheating. If you do I would try to move it and see if it still does it.
Maybe set it on a stand outside of encasement.

If totally dead it appears to be a power supply issue.

try degaussing its in the menu

Your telly has died a noble ***** and may need to be retired. T con board is responsible for images portrayed on screen.

If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.

Do a reset to this TV, and then check. There are two methods to reset TVs. The first is simple to do; a Hard Reset. The other is somewhat skilled; is a Factory Reset (System Reset). To make it a hard reset, just unplug the TV from AC mains wall socket, and re-plug it back after 15 minutes or so. If you do this by overnight is better. This procedure will make it a hard reset. If you want to make it a system reset [Factory Reset]; you have to enter its service mode option, and select the factory reset option. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Service mode entry, adjust and exit procedure to many popular brand TVs are given. Never forget to exit the service mode, after all adjustments have been done.