20 Most Recent Texas Instruments PocketMate 300 Questions & Answers

We have one u can buy if u have a pay pal account or other payment method. Call me 303 710-1924 Kevin or dj [email protected]

Selling my old (1997) Texas Instruments PocketMate 400.
Rarely used. In good condition, complete with manuals and dock.

http://shop.ebay.com/i.html?_nkw=PocketMate+400&_sacat=0&_odkw=PocketMate+400&_osacat=0&_trksid=p3286.c0.m270.l1313

http://www.hardreset.eu/index_en.html
Go to site above it has all codes for everything.

Press the key marked with the Greek letter Pi.

Please make sure you have fresh batteries in the device.

hiArguments are in an invalid order, try multiplying the 5.8 with the other two terms (2pi/365)(x-196) that way yo might be able to graph it.

Mrmojorisin1

it appear because of a defective hard disk drive or a defective operating system or maybe a defective IDE cable the one who connects the hard disk drive through the main board. try to replace a new IDE cable. then if it still have the problem try to reformat the hard disk drive with a new operating system(windows xp etc..)if still the problem occurs try to replace the hard disk drive.. may this one helps you

It's more likely that the carbon drawn contacts under the silver pushbutton top need to be cleaned, or traced with a conductive pen.

Here is a link to the manual online:

http://education.ti.com/guidebooks/graphing/8992p/8992bookeng.pdf

Good Luck!

hi, The VERY first thing we MUST check, is the PSU, check this exhaustively, even if possible replace with a know good, as if this isn't 100% A OK, NOTHING else can be..then well ADC 101 says that if there is NO output from the ADC, then this can only be due to 2 reasons, one, it is Inhibited, two, there is NO DATA to be converted/coming out? We need to find out why?

You need to use a 'scope and view the input and output signals along with the lines that control the IC, data flow, Inhibit etc, and see if all the lines are in the correct logic states, work back along either the control lines or signal, and work out why either it is inhibited or lacking signal.

Also check that you micro, isn't inhibiting it either?

Start at the beginning, where the analog signal is presented, and follow a line(s) along through the circuit with the 'scope, checking where they enter the conversion IC, then look at the Output(s) and see whats what, now if all control lines are set OK, and there is NO output then that IC must be faulty... anyway follow the signal along and see why it's not working..

unfortunately there could be many, many conditions that can cause this type of thing, one simply? must work through each block of the circuit, isolating sections if possible and viewing the activity on a 'scope to see where it all goes wrong. checking the voltage and signal levels are correct.

Press 2nd, then press Decimal (STO) key