20 Most Recent
Fargo Persona C30 Thermal Card Printer - Page 6 Questions & Answers
ID WILL PRINT, BUT THE
I have obtained photo quality finishes by giving the finished product several thin coats of aerosol lacquer spray. If this will solve your problem I cannot say, but the possibility is there so give it a try. Good luck.
Test
> test
Test of "write a solution for this problem".
I have a Fargo HDP5000
Hi,
Think you port has been used by some other device by which, your device conflicts with other device, To resolve this try using the printer in some other ports/. THis should solve your problem.
If this doesnt solve your problem you can directly open support ticktes from the following link, for free
http://www.fargosupport.com/contact.asp
RNJ VINOD KUMAR
My DTC 400 bladge printer
The DTC400 has an o ring that drives the card feed rollers. Fargo has had a problem on older DTC400 printers with the o ring stretched or broke. This causes irregular feed roller issues, ribbon breakage or misalignment of print registration.
It is recommended to do a
ribbon sensor calibration. This can be done through your print driver using the directions in this link.
Your DTC400 came with a two year manufacturer warranty. Contact Fargo Technical Support at 800-459-5636.
For more information about
id card printer systems, visit our website at
www.safecardid.com
Not finding what you are looking for?