Brother DCP-330C All-In-One InkJet Printer - Answered Questions & Fixed issues
My printer OCR command does not respond. The
- faq000559_002
When I try to OCR into WordPad using the ScanSoft® PaperPort® SE with
OCR or the Brother ControlCenter3, the text comes out as gibberish.
This started after I installed Windows® XP Service Pack 2 (SP2). Why and
what should I do?
- faq000093_012
What is MFL-Pro Suite Software?
- faq002613_000
When I try to scan to OCR I get an error message saying "This feature
is not available because there is no OCR Software installed".
- faq002561_000
How do I configure or change the settings of the ControlCenter 2 or 3 scanning options?
- faq000562_002
When scanning to OCR from Brother Control Center3, the OCR
application doesn't launch. I have Windows® XP Service Pack 2 (SP2)
installed. What should I do?
- faq000563_002
When scanning to OCR from PaperPort® SE, the following error message
appears: "System error incurred in external ink module EZText.g32. The
OCR server is unable to process the document". I have Windows® XP
Service Pack 2 (SP2) installed. What should I do?
- faq002620_008
Windows® 7 Support Information
Enter maintenance mode
Menu. Black Start(Mono Start), Menu and Black Start(Mono Start) "Maintenance 10" will display on the LCD
MY BROTHER PRINTER DCP-395 CN ERROR IN UNABLE TO INTI 4F PLEASE SOLUTION
This error is associated with the self test the printer does on the print head during power-up of the printer.
Sadly, it is indicative of either a faulty print head or a faulty main control board, neither of which are easy or inexpensive to replace.
Unless you can get hold of another machine with a different fault and swap over the print head and/or board (you'll need very good skills and tools to do this) then I'm afraid the machine is beyond economic repair*.
* Brother will repair your machine but the cost will likley be more than a new one.
UNABLE TO INIT. 4F ERROR
This error is associated with the self test the printer does on the print head during power-up of the printer.
Sadly, it is indicative of either a faulty print head or a faulty main control board, neither of which are easy or inexpensive to replace.
Unless you can get hold of another machine with a different fault and swap over the print head and/or board (you'll need very good skills and tools to do this) then I'm afraid the machine is beyond economic repair*.
* Brother will repair your machine but the cost will likley be more than a new one.
I have lost my instalation disk can i still
Sure. Go to the manufacturers website at:
http://welcome.solutions.brother.com/bsc/public/us/us/en/dlf/download_top.html?reg=us&c=us&lang=en&prod=dcp330c_all
and this will allow you to download the printer driver.
I can't print out doccument,
press
"menu" "black start" and "up arrow 4 times".
that gets you into maint.
mode to be able to reset purge counter.
next enter code "80" by pressing
up/down arrows and pressing "ok".
press "black start" several times
until you see "purge count".
now press "2783" and "ok" to reset purge
count.
then press "black start" about three more times or until you see
flushing count. again, press "2783" and "ok" to reset. now hit
"stop/clear" a couple of times and press "99" to exit or use arrows to
get to "99" . at this point, you may have to press "ok" to get out of
maint. mode, but i think once you press 99 it backs out automatically.
next time this comes up however, you will need to have your ink absorber
box and flushing box replaced.
Not finding what you are looking for?