20 Most Recent
Brother DCP 130C All-In-One InkJet Printer - Page 4 Questions & Answers
Need help! ! ! !
...and what error code (two digit) does the machine display, too?
We cant give you an advice without knowing the error code.
Where do I plug in the cable from my Brother DCP130 PRINTER into my PC.
Using both hands, use the plastic tabs on both sides of the machine to lift the scanner cover until it locks securely into the open position.Insert the USB cable into the USB socket marked with a symbol. You will find the USB socket inside the machine on the right.Carefully route the USB cable through the trench and out the back of the machine.Lift the scanner cover to release the lock. Gently push the scanner cover support down and close the scanner cover.Turn on the machine by connecting the power cord.
Driver-mac
you need to use generic driver for MAC... What kind of MAC OS are you using? MAC 10 have the drivers installed on the computer and you don't need to install the software.
Clean unable 46 on brother
HI,On most Brother MFC machines it is the buttons: function, *, 2, 8, 6, 4, hit the buttons within 2 seconds and in order like push function than push *, than push 2. and on within 2 seconds.If you do this right Maintenance should show up in the display. Now press 01 which clears all memory and puts the machine back to factory default. Realize that all addresses in the fax and cover page will be gone and you will need to set it up again. Now hit 99 to leave maintenance mode and try the machine.
My brother printer DCP135C have
Try to reset DCP printers without numeric keypad.
Follow this:
1. press buttons Set, Menu, Mono Start one by one, followed by up arrow key four times. this should all be done as short a time as possible, around 3 seconds.
2. enter maintenance mode 80 by pressing the up/down arrow key and set key to select numbers 8 and 0
3. press up arrow key several times to get to the Purge item
4. enter 2, 7, 8 and 3 using arrow/set keys to reset the counter
5. press Stop/Exit key to go to root of maintenance mode
6. enter 9,9 to exit maintenance mode
Don't forget to vote Thanks!!!
Hi, i cant get my
Hi,
The following may work: remove all the ink supplies. Remove the printhead and soak it for about 5 minutes in 0.5" of very hot water. Gently blot the printhead on a soft damp paper towel to remove the excess water, then replace in the printer and then reinstall the ink supplies.
Not finding what you are looking for?