20 Most Recent AOC Envision L32W461 32 in. LCD HDTV Questions & Answers

This might be a screen driver problem that cannot be easily repaired without replacing the whole screen assembly. It may be cheaper to replace your TV. Ask a repair shop for a repair quote.

This sounds like it may be a problem with the high voltage power supply that provides power to the fluorescent tubes that illuminate the screen.

You need to plug an RF cable into the RF Input. Connect that to a TV antenna, cable, or satellite receiver. You will need to run a channel scan to allow your TV to know what channels are available.

Look for the manual control button the said INPUT.Pushes couple times,now u will move within HDMI modes like 1,2,3.

it seem like capacitor is gone, as it is obvious that you do have limited knowledge of the tv, i would suggest sending it to the workshop, most aoc tv have two or three year warranty, you can check they warranty on this site: http://us.aoc.com/support/warranty select product and then model number and follow instructions, if it is still under warranty - your problem is solved, fill online form and that will be that, in most countries they even organise pick-up. if it is out of warranty, on this same site you can find recommended repairer. hope this will help you solve the problem, do not forget to vote...

Vertical lines can occur due to a loose contact of LVDS cable, to display panel and T'Con board. Re-seat it once and check.

If you wish to get more details, surf the following link. There are over two thousand and four hundred posts. All are related to television and other domestic electronic equipment service help. You can get a solution there. Type in the brand name to your device to its search box, can be located at the top right of the display window. It will make search easy. More than Nine and half Lakh viewers cannot be wrong.http://electronicshelponline.blogspot.com/

Pull the batteries out of your remote. Does it still flash and yell at you? If no, replace your remote. If yes, call the manufacturer, they should be able to point you in the right direction regarding your Envision. I'm not very familiar with your model, but it's not a problem I've encountered before. Since your remote doesn't work perfectly anyway, it could be causing exactly what it is that your describing. Your OK button could be stuck in the depressed position, like it's being held down, and since it's usually near the volume buttons, it seems to be the most likely cause.

Based on the brand parts may not be available and six years is better than average life for this type of set.

Check the volute settigs to these channles. Check whether system set is compactable with input.