Pentax Optio M20 Digital Camera - Answered Questions & Fixed issues

Take a look in your camera's menus. There should be a place where you can select rechargeable or non-rechargeable batteries. That setting enables or disables the battery charging circuit. If you are using rechargeable batteries, the camera must be set accordingly so that the battery charger will turn on. If you are using Alkaline batteries such as Duracell or other types of non-rechargeable batteries the charger must be disabled. If you do not set that parameter correctly, you will get the symptoms you describe.

Some can if there is a small hole for a pin to push in. Most can take out the battery and and reset the camera. But most can not reset the lens retraction. Its hard.

I dont know this specific camera but most like this will have a little sliding opening on the bottom of the camera. If unsure then have a look at the manual.

If you plug the camera in to a USB port it shouldn't need a driver. It should come up as another drive regardless of OS.

With the help of technology, yes. There is still a way for you to recover it. Download this software, install to your computer and then follow the instructions on how to recover your files.

By the way, until you have not recovered the files, please make sure that you will not use the card and store more photos on it. This is to help you ensure that you would still get the photos you need on the formatted card.

Here is one of the many softwares you can use for data recovery:

http://www.softwarepatch.com/software/smartrecovery.html

Take out the batteries and clean contacts with alcohol and a Q-tip the long ones like a doctor uses are better. If the batteries are more than two years old I would replace them. I take it that this camera probably uses AA. Reg. Alkaline batteries would be alright just to try it with if you get it working then I would put a set of lithium batteries in it as these last far longer.You can also buy rechargeable AA batteries. If it has a lithium L-Ion rechargeable battery pack and it is several years old you may want to buy a new one for it. There is several reasonable sellers on Ebay with the proper battery for your camera. If this don't solve your problem I would say the camera is done. In my experience these new cameras just don't last as long as the old manual film cameras.

Why do you need newer software? Updates don't come, beacuse a camera stops taking pictures or having problems. Most updates are little improvements for cameras that still work correct.Try to discribe what is wrong with your camera. Perhaps you need something els to solve the problem.

Remove the batteries and let it dry for good. To be sure all the damp on electronics evaporated. Put the camera on warm place (not to hot). You need to open all doors (SD card, battery etc..) even back cover to let the damp go out. Blowing dry air may accelerate the drying process. Install batteries when you sure all the water trapped inside has evaporated completely.

you can recover deleted photos from camera with camera recovery software like asoftech photo recovery.First of all, do not save any new file to camera's memory card.Take out memory card, and connect it to computer using a card reader. You should see memory card shown as a drive letter (like H:) in Windows Explorer.Download asoftech photo recovery softwarehttp://www.asoftech.com/apr/Install and open the photo recovery software, select the memory card, and click 'Start' button.

You can use the camera's Menu to format the memory, this will delete all your photos from memory.

The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

After attaching the cable to the USB port on your computer, it should see your camera as an external storage device. Click on My Computer and you should see your camera as a drive, click on this drive and open the picture folder, than you can copy these photo to your computer. ALTERNATE WAY TO TRANSFER PHOTOS TO COMPUTER If your photos are stored on the memory card, then remove the memory card from the camera and insert it into an USB memory card reader. Connect this USB memory card reader and memory card into the USB port of your working computer. Your computer will see this as an USB Mass Storage Device or an external storage device; you can then open the folder on the memory card and copy the photos to your computer. Memory card reader is a handy device and is inexpensive. You can copy photos from other cameras and you can also download photos off your memory card to someone else's computer without the need of installing any programs.

You don't need any special software.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or, despite what I said first, you can use any photo cataloging program such as Picasa.

It might be too pricey, but you can order a replacement part from here.

Consider NOT connecting your camera to your computer.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

Try the procedures in this tip.

You don't need any special software.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or, despite what said first, you can use any photo cataloging program such as Picasa.

Consider NOT connecting your camera to your computer.The best way to download pictures from your camera to your computer involves removing the memory card from the camera and plugging it into a card reader (either built-in to the computer or connected via USB or FireWire). This is likely to be faster than connecting the camera to the computer, and won't run down your camera's batteries.Once the card is plugged in, it will appear to your computer as a removable drive. You can use the operating system's drag&drop facility to copy pictures from the card to the computer's hard drive, the same way you copy any other files. Or you can use any photo cataloging program such as Picasa.

You may order a replacement part from here.

I took advice in PC World. The camera isn't configured for Vista but a way around the problem is as follows:
Download photos directly from camera to printer then take them off using a memory stick. Then transfer them on to the computer.
Thanks for your interest