WPA is a strong form of wireless encryption, however not all wireless
adapters support this feature. If your wireless adapter does not
support WPA you will want to use WEP to secure your wireless network.
You can find information on configuring your WBR router for WEP
here
Step 1: Open a web browser and type the IP address of the WBR series router into the address bar (default is http://192.168.0.1).
Step 2: The default username is
admin (all lower case) and the default password is blank (nothing). Click on
OK.
Step 3: Click on the
Setup tab at the top and then click on
Wireless Settings on the left-hand side.
Step 4: Select the type of WPA encryption you would like to use
with your wireless adapter from the Security Mode drop down menu. For
WPA-PSK select
Enable WPA- Personal Wireless Security (enhanced).
Note: All wireless products on the wireless network must have the same level of security to connect to the network.
Step 5: In the
WPA Personal section, configure the following:
- Select the Cipher Type
- Select the PSK or EAP
- Enter your Passphrase
- Re-Enter your Passphrase
Step 6: Click the
Save Settings button to save your settings.
If you need more help come back.Post / thumbs / testimonial are welcome!