Top 20 KitchenAid 24 in. KUDP02CR Built-in Dishwasher Questions & Answers

KITCHENAID DISHWASHER REBOOT - YouTube

? 4:17 www.youtube.com/watch?v=XJnzzXJcOV4 Sep 17, 2012 - Uploaded by DIYAPPLIANCEREPAIR How to reboot your Kitchenaid, Whirlpool, Kenmore by Whirlpool dishwashers control board. ... Up next. Dishwasher Repair will notstart - Repair & Diagnostc - Kitchenaid - Whirlpool ... Kenmore Elite Dishwasher blinking light Control Board FIX - Duration: 1:37. by ... Dishwasher Buttons Not Working?

Check your water inlet for the right pressure and then the water float valve for the right amount of water in the tub for washing. The tub has to have the right amount of water in it to pump it up to the top. It is also possible that the pump has debris in it that is restricting the flow. Clean out the screens and check the bottom of the washer tub for debris at the pump inlet. Use white vinegar to clean out your washer. Start your washer - open the door and pour in a lot of vinegar. Let it run for a few seconds and stop it. Let the vinegar work on the scale and debris. Start and stop it several times during the day - not completing the wash cycle until in the morning - after it has sat with the vinegar 10 -12 hours.

Try this, let the dishwasher run the quick-clean up cycle if it still can. Then turn it off at the wall. Unplug it from the wall. Give it a moment. Plug it back in, turn it on at the wall. with a bit of luck it should be up and running again. if not... Check the door is closed properly, it needs to click shut fully before the dishwasher will start. If all that fails, we could assume its more serious, there are different courses of action to be taken... If its under warranty then make the call to the manufacturer or store and go from there. DO NOT try and fix it yourself unless you are a registered electrician or serviceman. Good Luck

Note: Electricity can cause serious injury even Death. Isolate your power supply from the mains switchboard. Switch off and Unplug your appliance from the wall socket before attempting any repairs. After Isolating your appliance from the main switchboard, Check that the tap is on feeding the line to the Dishwasher. Check other taps in the house to see if your getting water to the house from the mains. If its hard plumbed and the water is on, and still no water... check the inlet filter on the back of the dishwasher. make sure you have turned the power off first. This could be blocked / obstructed with buildup grime from the water mains. After cleaning the filters/ Checking the water supply and restarting the Dishwasher and you get the same error message you will need to call a serviceman to analyze the problem further. DO NOT attempt to dismantle the Dishwasher yourself unless you are a registered electrician or a qualified serviceman. If its still under warranty call the manufacturer or the store it was purchased from, they can arrange a serviceman for you. Good luck and Take Care

Hello, cit I was trying to help you out here. I was going back to some customers that asked questions in the past and it appeared that no one answered them, so I thought I would take some of my personal time to see if I can help. Even though this site may not have your exact model or brand, This link will help you tons. Here is a link to about everything you want to know about your dishwasher, from repair to trouble shooting it,pictures, video's. Just scroll around and you will see tons of information to almost any question you might have on your dishwasher. If you go to this link and click around, I am sure you will find out so much about your dishwasher, you will know more that the company that made it. Here Is the link for you to click on>> http://home.howstuffworks.com/dishwasher.htm Please if this helped you at all, if you can find the time to rate my help and some kind words written would be appreciated for my free help , I would appreciate it. Here is also my direct link to my own pages of other areas of my expertise for other problems you might have in Automotive,Appliance, and Electronics. Drop In anytime for my help. Thanks,Mike http://beta.fixya.com/users/mc1bean

Hi,

This means the touch pad sense a stuck or shorted key. Try pushing in all the keys to make sure there not stuck. If not, the touch pad needs to be replaced.

The screws around the door come out and the assembly will slide forward. All plug and play type connections and a few 1/4 screws. The repair is really straight forward. Good luck with your repair friend

Link for all appliance model numbers.

Please post your entire model number.

After you have clicked on the link below....

Just to the right of the "search" tab click on "help me find my model number"

Just click on the model of your choice In either video or image presentation

Then please repost the information.

Click on the link http://www.repairclinic.com/Appliance-Parts

Thanks....

Keith

Hi,

The timer/control board has gone bad and will need to be replaced...

That is not that hard to fix and you can easily buy the parts yourself online...

Here is a tip that will help you with the online buying...

How to Buy Appliance Parts Online

heatman101

Your filter/chopper is clogged. You have to clean it out and that will restore water pressure to the top rack.

1. Remove the bottom rack.
2. Remove the top rack
3. Remove bottom Spray arm (turn top nut clock wise)
4. Take off the delivery tube by turning it clock wise over the heating element ( undo the two clips one at the back and one on top)
5. Take out the screw for the top screen and remove top
6. Take one screw out for chopper housing and remove
7. Remove chopper and clean or replace chopper if broken

Reinstall all parts and test.
That should help please rate your experience. Thanks

The problem is most likely that there is still water residue at the bottom of your machine. If the machine is not fully drained it picks up some of the residue and sprays that onto the dishes during the final rinse, leaving an unhealthy and unsightly film on everything.
Remove the bottom strainers and make sure that there is nothing obstructing the outlet pipe and the pump. If possible back flush through the outlet pipe and try draining the machine again before using it again.

Hi

If clean light is blinking then it may be an issue with heater circuit, door switch or wash pump. If yes then please reset the power to the dishwasher. After, 5 minutes check if you are still getting the same error. If yes, then it is a water heating fault. To resolve this error try pressing this reset sequence-- Heat Dry - Normal - Heat Dry - Normal or High Temp - Air Dry - High Temp - Air Dry or Hi Temp Scrub, energy saver dry, Hi Temp Scrub, energy saver dry. Now let the unit run for 2-3 minutes and then you press the Cancel/Drain button and allow it to completely drain and reset. If this doesn't work then it's an issue with the wash pump not pumping the water past the heater efficiently or due to lack of water to heat. Please make sure that heater is not open circuited and is heating the water efficiently. You'll have to check the heater using a multimeter; the meter should read between 3000 to 3300 ohms (Use multimeter on Rx1 ohm setting). If heater is fine then make sure water pressure is optimum and fill valve is working fine. Hope this helps... Please post back for further assistance.

Daniel

Hi,

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...

Dishwasher Spray Arms not Spinning

How to Buy Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

Dishwasher Residue and Film on Dishes

heatman101
/\\\\\\\\\\\\

Reset the control again. Then change out your heating element.
That should fix it good.
Have a great day!

There is a drain hose that runs under you sink
It will run into a drain pipe under the sink or into the disposal
Remove that hose and check for obstuctions by pumping into a bucket
If that doesn't work check the drain in the bottom of the dishwasher.
There is a filter there that may be plugged.
Hope this helps

Hi,

I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess things up bad... So I would buy new spray arms, and also check out the heating element to make sure it is working... Here is a tip that will help you with the online buying...

Dishwasher Spray Arms not Spinning

How to Buy Appliance Parts Online

A bad heating element causes many problems in dishwashers...

Dishwasher Problems The Heating Element not Working

Dishwasher Maintenance

Dishwasher Residue and Film on Dishes

heatman101

Asker's Testimonial "explanation very clear. will give it a go and see how simple it was. thanks Ronnie " - ronnieshomes

Hi,

Here are the parts you need to fix that...

http://www.repairclinic.com/PartDetail/Hinge-Cable/1059756

They should not be very hard to install...

heatman101

Yes, this will tend to happen with aluminium in a dishwasher. All you can do is to experiment with different brands of dishwasher powder/tablets. Some only leave the aluminium dull and grey.

Hi,
Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...

Dishwasher Problems - Water will not drain out

heatman101

Hi

Thanks for using FixYa. As you have already replaced everything else so the issue is with the door switch going bad and should be replaced however, if that switch is fine then it is the control that is bad and should be replaced. Please accept the solution if the issue is resolved or post a comment for further assistance.

Thanks

Rylee

Hi,

The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.

Here is a tip that will help you to solve the problem of films, residue, and scum in your dishwasher.

Dishwasher Residue and Film on Dishes

heatman101

[][][p