Top 20
Hobart 29 in. AM15-1 Free-Standing Dishwasher Questions & Answers
Refill solenoid not working
measurement on refilltime of programclock cable to solenoid or the the metal disc valve is stuck with lime little chance that lingers.
Take off the two connection slide contacts and the solenoid coil of the shut-off valve to measure the flow passage
What brings on the P1 indication
Indicates problem with the temperature probe. Look in the tank where the float is and check to see if it is covered with debris. The float has a magnet that collects metal particles. The metal probe that is under the float is the temp. probe.
Display lights all on
some early machines were known to leak from around the front door supports, causing water to leak into the controls. Check the connections to the display and keypad. Please be more specific regarding a noise. is it all the time the pump is running? is it a contactor chattering?
If you are going inside to check, keep in mind there could be atleast two circuits powering the machine and its booster.
Practice lockout, tag out, at all times
Reset
turn OFF the c. breaker from your panel breaker. Wait by 45 seconds, and activate again ON the . c.breaker.God bless you
When hood is lifted up water do not stop running,
Hello,
There is a magnetic switch underneath and behind the panel I think its at the front or side where the lid sits.this may be faulty but sometimes they can drop out of line,look up inside hood for other half of sensor this may have come loose 2 screws holding it in.
Hope this helps.
Hobart lx30h rinse additive is running all the
The main cause is the "anti flood" device at the bottom of the washer that detects a water leak "hose leak" etc. This device made up of a polystireen float and micro switch is a safety device and when activated puts the washer in pump out mode only. You need to look at the base of the washer and see if water leak has caused this. Rectify the cause "normaly hose or clamp" and this should clear the
Not finding what you are looking for?