20 Most Recent Hobart 29 in. AM15-1 Free-Standing Dishwasher - Page 3 Questions & Answers

The main cause is the "anti flood" device at the bottom of the washer that detects a water leak "hose leak" etc. This device made up of a polystireen float and micro switch is a safety device and when activated puts the washer in pump out mode only. You need to look at the base of the washer and see if water leak has caused this. Rectify the cause "normaly hose or clamp" and this should clear the

Click on the link below to purchase replacement parts for your LZ30H from Hobart

http://www.hobartservice.com/Parts/

Either the door is not shut all the way, or the door seals inside the grooves are missing or bad,

p2 would mean your rinse thermistor is open or shorted. its located on top near the the right side, after the vac. brkr. part# is 328994. remove old, istall new . dont forget to vote,hope this helps , monomoy

This may not help but it is all I could find. https://feg.hobartcorp.com/resourcecenter/ProductDocumentation/F34123%20Rev%20C.PDF

After checking the service manual, I find no code for E1. There is a P1, or other E codes. Please list ML number.

If it is new, would you not call Hobart for a warranty call? 1-800-444-4764 to reach the nearest branch in Canada.
Seeing it's new it is most probably not programmed correctly. On the control board is factory jumper J5, short thse two pins and press ON on keyboard. when the display shows ty remove short. pressing select on the CB will change the options, pressing up arrow will incriment the change options. first setting is machine type= AS,second is id, hot/cold or plain AM15 only, select H,C,or P.
3rd is tc,auto temp control. The rest will not affect your condition. Press OFF on keyboard to save and exit.

cant be done sorry

Asuming you have an AM15, Check you have power to the fill valve during fill cycle. Make sure your drain is closed to retain the fill water. You should have 20 psi flow rate.

Sorry so late,i would check the motor vents on the motor to make sure their not clogged.Any questions let me know.

Goto hobartcorp.com

What is the exact model number and ml number?Is it definetly a e2 error or p2?

Is this single or 3 phase? What happened?I'm a hobart tech.

What do you mean? A longer rinse cycle?I'm a hobart tech.

I'm a hobart tech and repair these units often.I can tell you this---If you open up the control panel and see water the wash tank has a crack in it.If this is the case depending on the serial number you may be able to get a new dishwasher.What happens is the water gets onto the electronics and shorts out.What is the exact serial number,model number and ml number?How old is it and where are you located?Have you had any repairs done by hobart or any other service company?

That connection was probably a little loose and caused that. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

go to http://www.hobartservice.com and request from them if you cannot find it in there search pages

First chech the machine is warming the rinse water and not rinsing in cold water then have your chemical guy come and check that the soap/rinse ad dispenser is not dispensing too much rinse aid and naturally make sure the machine is in fact ricing with water I have had it where a glass washer takes more rinse aid then i should and does not actually rinse with clean watr it was simply spraying the rinse aid wich sounded as if it was rinsing soulution was new pc board it was not changeing programs properly if you have and older machine it proberly has a timer this too can be a cuase of the problm if it is not clicking over to allow a full rinse cycle.Hope this helps let us know.