20 Most Recent
Kenmore Oasis HE 27082 Top Load Washer - Page 5 Questions & Answers
Washer will not power on and lid is locked
Unplug it and wait a minute or two, the lid will release. Take out the clothes, plug it back in, put it in spin and close the lid. If it goes back to work, good. If not, check Repairclinic.com for repair clues.
Very loud spin cycle
your bearings i the tub have gone bad. It happens usually if you use powder soap. It doesnt dissolve all the way and gets into the bearings and ruins them. Sorry but this is a pretty expensive fix. When you get it fixed used liquid soap and it shouldnt happen again.
Need to bypass lid lock on cabriowtw7300xwo
You can open the top lid by inserting the putty knife under the top part. There are two clips holding the top part. When it pops up you can open the top part when the lid lock remains working.
Continous cycles
Replace the user interface board. It is the board mounted to the inside of the console.
While in the middle of wash load, an error light
A code of "SD" indicates the washer has entered its "Suds Routine." That happens when an excessive amount of suds is detected in your washer, and the machine changes operation to remove the suds for proper rinsing of your load. The code will clear itself once the "Suds Routine" has finished.If it keeps doing this each load, try lightening up on the detergent.
Kenmore oasis hf 2706 2603 has not cleaned since
Possible that the inlet is clogged and needs to be flushed out. Also the drain could be choked and allow to drain the water after a cycle.If this was not done for a long period the performance would drop.The water level is set according to the clothes quantity and is adjustable. If not the water pressure sensor can be faulty.
Not finding what you are looking for?