20 Most Recent D-Link DCS-950G Network Camera - Page 6 Questions & Answers

I attempted to use D-link equipment TWICE in the past... I went as far as wasting a net of 3 hours each time with their "TECHNICAL" support... OVER & over... to the definition of insanity... Had anything worked I would tell you ABOUT IT. I would strongly recommend you return them from WHERE-EVER you purchased them... NOW. My next was a single unit NETGEAR... Cost less and I had cable connected my video server WIRELESSLY... in a matter of minutes. My OPINION: Avoid the pain. Carnac the Magnificent

Instead of removing the antenna from the router you can buy a cheap working second hand router in market (better buy a second hand belkin router, because belkin provides free lifetime phone support also free lifetime hardware support for certain routers whose model numbers starts with F5D or F6D....Dont buy any belkin routers with model number that starts with F7D)

Now configure the second router as an ACCESS POINT (you can call 18002235546 to get help to change to an access point)
run a long ethernet cable from dlink router to the second router (belkin)... you can place the belkin router anywhere where the cable can reach...
The belkin router will broadcast the signal and you will get better signal strength...

Can you access msn.com via command prompt?

Not all antenna are removable, if it does not easily unscrew, it is probably not removable.

You may hard to do a factory reset and then reset all your info. You can reset your router by finding a small hole on the back side of the router, then using the tip of a paperclip, push into the hole while the power is on and hold or 10 seconds and this will reset to factory out of the box settings.

Login to the router using your browser and go to wireless section where you can change both the SSID and password/key