Hi !
i have replaced my 2.4 celeron(400) with a Pentium 2.8 Ghz (L2 512 800bus) processor. But "Micro code update error" appears on starting with F1 prompt. Pressing F1 it goes well. I updated bios to ver 2.43. But it could't fix the problem. What should i do now
Regards
Faheem
Go into the bios select fail safe settings then save.
Posted on Mar 01, 2008
I have am looking to upgrade the on board grahics by use of the AGP slot or by use of one of the two PCI slots. Can you recommend a particular card that will fit inside this SFF PC. I need a card of DirectX 7.0 or high preferably? and unsurprisingly I am not looking to pay the earth!
Thanks
Julian
Try this site:
http://www.geeks.com/products.asp?cat=VCD
The ATI Radeon HD 2400 256MB PCI-Express VCD w/TV-Out DVI seems to me to be what you are looking for..
Good Luck!
Posted on Apr 18, 2008
Please I would like somebody to helpfinding a driver for my home computer. this occured when i counceled some temporaries files. since that time the sound does not come out.
this is my characteristics
HP Compaq d530 SFF
I found the drivers I needed at http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=316715&lang=en&cc=us&prodTypeId=12454&prodSeriesId=316713&taskId=135
I am running XP and used SoundMax Integrated Digital Audio for audio &
Intel Graphics Driver for Microsoft Windows 2000/XP for video.
Posted on Aug 19, 2008
my hp can`t on.i haz cut smart lock but no respon.i need manual book. Front header wiring information. I have no sound. I am installing a hp d530 sff motherboard into a standard tower. I purchased the motherboard only and now I have no sound from rear audio connectors.
You are missing the front headphone / microphone connector that plugs into the motherboard. Or a way to jump this to close the headphones so the sound will come out the back.
Posted on Aug 19, 2008
My HP Compaq d530 Small Form Factor Desktop PC processor fan is running always in high speed, I will check in bios to control the fan speed. I adjusted the speed to low in bios but it is practically not changed. I will change the fan with another one but no change will occured . how can I control or lower the speed. Pls. inform me.
The fan/heat sink on these models get plugged with dust very easily, use an air compressor or can of air to blow the dust out of the heat sink and fan. In extreme cases the thermal paste gets dried out and needs to be re-applied to properly cool the processor.
Posted on Feb 10, 2009
HP D530 SFF MOTHERBOARD HAS BEEN PLACED INTO NEW CABINET .
WHEN BOARD BOOTS ERROR 512 - CHASIS FAN NOT DETECTED APPEAR
LET ME KNOW HOW TO DISABLE THIS ERROR
THANKS
tell me the wright way to remove 512 chassis fan error i am very depressed on this
Posted on Jul 22, 2010
Ethernet driver for hp Compaq d530 sff on board
Drivers are located here: http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=316715&lang=en&cc=us&prodTypeId=12454&prodSeriesId=316713&taskId=135
You must select the appropriate operating system for your application
Posted on Apr 25, 2009
920-fan command 2 pin connector from power supply not connected
I have replace my power supply..but my new power supply didnt have the 2 pin..
Well thats not good, however if you can identify the Positive, usually RED, and Negative, usually BLACK. on the Fan, You can actually carefully insert the bared wire into a spare drive power connector, fans are all 12 V. You can use the YELLOW.. +12V & the alongside BLACK - 0V. This will power your fan. BE CAREFUL doing this. Once inserted use a piece of tape to secure the wires and fold them back against the Plug and secure. You may be able to buy a converter that plugs into that power connector & the fan?
Posted on Feb 22, 2010
what cause error code 511 cpu fan not detected
3 wire conductor fan. The 3RD WIRE IS THE fan sensor located in the fan's electronics this is malfinctioning come in tthe construction of the fan itself.
Posted on Aug 23, 2010
Audio drivers Hp Compaq D530 SFF running on Windows 7 ultimate version. i would not mind all other Windows 7 drivers for the same machine
Download the XP drivers and install them. It will fail to install but it will extract what you need on the computer.
Manually install the drivers though control panel and point to the extracted files "C:\swsetup\SP27103\" (might not be 27103 depending on the drivers version) Make sure include subfolders is checked.
That worked for me.
The graphic drivers are a different story you need to start with the vista drivers. Google is your friend.
Posted on Jan 19, 2011
412 questions posted
Usually answered in minutes!
5,069 Questions
2,066 Questions
1,757 Questions
1,195 Questions
1,096 Questions
