20 Most Recent
Uniden TRU9488 Phone - Page 3 Questions & Answers
My uniden DSS7855 with 1 base station and 3
Clear the Handset's Base Data
- To remove the base data from a handset when out of range of the base, press and hold the 'end' button and the '#' button simultaneously until the phone beeps.
- It will now be de-registered from the base.
Note: This requires that the base and handset can communicate with each other.
Clear the Base Handset Data
To de-register all handsets from the base, remove power to the base, and remove the handset from the base.
Press and hold the 'flash/find hs' button while applying power.
Wait for the beep and release the button.
The charge light will now flash.
Sit any handset in the cradle.
When the flashing stops, re-register the handsets to the base.
Re-Register a Handset to the Base
1. Remove Handset Battery.
2. Reconnect battery while holding down "*" and "#" key.
3. Then press the right upper key under the LCD.
4. Press the "End" key.
5. Wait a few seconds and then the phone will be ready to register to the base. I’m happy to help further over the phone at
https://www.6ya.com/expert/jeremy_69f3cc28d95bf514
Using my Uniden Dect 6.0 cordless phone, been talking for awhile and now it keeps disconnecting after only about a minute of connection.
Hello Lynn:
Make sure the power cord is securely plugged into the telephone base. Plug the telephone base into a different working electrical outlet not controlled by a wall switch. Move the handset closer to the telephone base. It may be out of range. Reset the telephone base by unplugging the electrical power to the base. Wait for 15 seconds and plug it back in again. Allow up to one minute for the cordless handset and the telephone base to synchronize. Other electronic products such as HAM radios and other DECT phones can cause interference with your cordless phone. Try installing your phone as far away as possible from these types of electronic devices.
Not finding what you are looking for?