20 Most Recent Motorola Mobility H3 Bluetooth Headset, Black Headset - Page 5 Questions & Answers


Many police have gone to encrypted radio, so you may not be able to get that on most cheap scanners. even much more expensive scanners won't do it without a modification, but that is not legal to do that.

Radio... | Answered on Oct 23, 2019


Try using the manual if you can't see any button that say time, or menu on it. That radio is subject to a lot of complaints, that is what you get when you shop for cheap electronics. Some buttons have to be held down for a few seconds to get into a hidden feature, like setting the time.

Radio... | Answered on Oct 23, 2019


You might have to reset it, that is if it paired before with the same device. Know that Blue Tooth has different versions and some don't work with other versions of bluetooth. But your post sounds like it worked before you reset it, so it may just be that easy.

Radio... | Answered on Oct 23, 2019


Radio frequencies are different from country to country. NZ will use different frequencies than Canada. Canada and the USA have agreements in place because they border each other on what freq. is used for what. NZ likely has its own list. Your radio is not programmable to NZ frequencies. Sorry!

Radio... | Answered on Oct 23, 2019


Connect the headset to the charger as if you were charging it, but keep one side in your ear. Once connected to the charger, hold down the power button. It'll beep a few times and then stop. Disconnect from the charger. You can then turn the headset back on. This "procedure" clears the headset's memory,

Radio... | Answered on Oct 16, 2019


Radio Shack has a pretty good search feature for old instructions on their website. You will need their part number off the unit, which will be something like "20-321". Do a search and you can get a PDF instruction manual for it online.

Radio... | Answered on Oct 14, 2019

Tip

How to manage a long waiting queue in restaurant/clinic/service centre?


In Singapore, we noticed that many restaurant/clinic/service centre/etc usually forms a long queue either waiting for table or seeing a doctor or waiting to be served.

It seems that none of the owner are keen to look into a better system to resolve such unpleasant situation. In fact, you will notice that loss of business due to frustration queuing (esp. restaurant), angry customer (esp. service centre) and fear of contact (esp. clinic) in most cases.

Here is a great solution that I would like to introduce to have the above issue resolved. Check out the paging system by Blufi Wireless Singapore Pte Ltd, it helps to resolve most queuing challenge.

on Oct 09, 2019 | Radio Communications


go to cellphones. This is radio communications

Radio... | Answered on Oct 04, 2019


Your antenna should not make any difference with power or receiving. Is the scanner mobile or in a room? Hard to imagine the connector being broken. You could test the antenna or even the BNC connector on the scanner. Try another antenna. If you wiggle it, does it start receiving? You may have a short in the BNC to the receiver. Other than that, look to power issues.

Radio... | Answered on Oct 04, 2019


It sound like your power supply is not providing enough output for the radio. Are you by chance using a wall wart for power? You need a dedicated 12 volt power supply, made by Astron, QJE, or Pyramid.

Radio... | Answered on Oct 03, 2019


you may have a bad squelch pot on the radio. try turning it fully in one direction an back in the other direction. it also could be that the Pot is dirty get some contact cleaner and open up the radio and squirt a very little cleaner into the open spot of the Pot. then rotate the know several times. if you do not have something like CRC QD Contact Cleaner you can get it in a good hardwood store like ACE or TrueValue, and even Home Depot. you can use only 91-99% Electronic Grade Isopropyl Alcohol, do not use the 70% Isopropyl Alcohol.

Radio... | Answered on Oct 03, 2019


you may have a broken wire in the radio itself? or there is a wire broken inside the mike itself not just the connector.

Radio... | Answered on Oct 03, 2019


you need to program the correct frequency. the Marine Channel 63A is 156.175Mhz. they also maybe using a PL Tone or a CTCSS tone, you have to find out what it is. using the Chirp Programing software you can do that. but remember sometimes a Cities use a non standard CTCSS tone so you can only hear each other

Radio... | Answered on Oct 03, 2019


What radio do you have? Cannot give you any answer without knowing what it is?

Radio... | Answered on Oct 03, 2019

Not finding what you are looking for?
Motorola Mobility H3 Bluetooth Headset, Black Headset Logo

38 questions posted

Ask a Question

Usually answered in minutes!

Top Motorola Mobility Radio Communications Experts

Lawrence Oravetz

Level 3 Expert

10543 Answers

Brad Brown

Level 3 Expert

18157 Answers

Dennis

Level 3 Expert

962 Answers

Are you a Motorola Mobility Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Motorola Mobility Radio Communications

  • Motorola Mobility Radio Communications

Most Popular Question

get pin

  • Radio Communications
Loading...