20 Most Recent Panasonic KX-TG5632 Phone - Page 6 Questions & Answers

http://service.us.panasonic.com/OPERMANPDF/KXTG6021.PDF

You can record your own greeting message (max. 2 minutes) that is played when the answering system answers a call. If you do not record a greeting message, a prerecorded greeting message is used. 1 {GREETING REC} 2 Within 10 seconds, press {GREETING REC} again. 3 After the base unit beeps, speak clearly about 20 cm (8 inches) away from the MIC. 4 To stop recording, press {STOP}.

okay all u have to do now is to flash down your mobile phone

Thanks for giving me the opportunity to help with your problem.

The "ringer off' message on the base display is referring to the ringer on the "base" unit not the phone ringers. Your phone handset(s) will still ring even when the base ringer turned off.

To turn the ringer on the base back on press and hold push the ^ symbol on the base until it beeps two times, To turn the base ringer off, press and hold the v symbol until the unit beeps.

If my information has proven to be of help, please give me good rating. Thanks for using FixYa!

try clearing all the messages first

Normally to raise the ringer volume you have to press the center button on the phone going upward. and you can only do this while the phone is not on a call. The volume of the ringer should go up... If you need further help, reach me via phone at https://www.6ya.com/expert/jim_8aa10a90cbbc76ff

To quote from your manual:
http://www.fixya.com/support/p475286-panasonic_kx_tg5632_phone/manual-19838/page-41
Pages 41 - 42
The default remote code is 11 (two ones).
1 Dial your phone number from a touch tone phone.
2 After the greeting message starts (before it ends), enter your remote code.
The unit (then) plays back new messages.
After playing back new messages, the voice guidance starts.
3 Follow the voice guidance as necessary.
4 When finished, hang up.
--Dave

When I went for batteries for MY KX-TG5632, I found they were $20.00 each. I also found I could purchase an entirely new telephone system (base and 4 satellites and chargers, five complete wireless telephones) for just over $95.00. So, I dumped my otherwise perfectly good, but old, telephones and bought the new system.

If you want to get new chargers and batteries, www.batteries.com is a good place to start ... You can go to many of the Big Box stores, Radio Shack has a good selection and there are many other fine retailers where you can purchase these batteries, including several FixYa.com advertisers.

Thank you for your interest in this web site.

Hi,
Life of this battery purely depends on our usage only.Recharging it after it becomes empty enhances the battery life.Even nor charging it frequently increases the battery life.Normally the life is around 1 to 1 1/2 years.
Thank you

Hand each phone up on the base and it will marry it. If you continue to have no link to base make sure everything is plugged in correctly. If it persists you probably have a defective phone.

Caller ID information is sent after the first full ring. If the call is answered too soon, the caller ID information may not have been sent yet. Some of the many and varied networks do not send caller ID information. In this case you may notice that caller ID is missing only on calls from certain callers. Occasionally bad data is sent, causing your phone to reject it.

Please set the unit to charge in a known working jack. Wait for several hours to pass befoer attempting to start it up again.


Spanish speaking available for all problems Thank you for allowing us to help, please respond with further questions and concerns

Best thing is ,You must repair your phone from a phone shop.

Call forwarding as you're describing is a service offered by your phone service provider, not a function of the phone. If your phone service package doesn't include call forwarding, you'll need to contact them to see about getting it. If you do already have the service, they will be able to tell you how to activate it and enter the number you want calls forwarded to.

All you can do from the phone itself is set up an outgoing message to inform your callers that you are away, and give the number they should call to reach you. You can also call your phone while away and check your messages, but it's a hassle. Call forwarding, especially if it's to your mobile, is definitely better.

With Panasonic phones the volume of whatever function is active can be adjusted with the arrows button. While it is ringing use the arrow up or down to adjust ringing volume. When off hook (you can hear dial tone or you are on a call) use arrows to adjust handset volume.

normally, that would indicate that New messages have been recorded and you have to Listen to the new messages. otherwise, Unplug the base unit's AC adaptor to reset the unit.
Reconnect the adaptor and try again.