20 Most Recent Sony Cyber-shot DSC-W30 Digital Camera - Page 9 Questions & Answers

mine did the same thing and i super glued it with a tooth pick.. but then a few months later it came off again and i lost it. i looked on the sony web site and there is nothin about replacing the part and i couldn't find a service center at all, you can send it off to get it repaired but it is a flat rate of $91. That is also the amount of a new camera. I would try to call the support line its 1800488sony. They are only open at certain times though. Wonder how many of these buttons have popped off. They aren't very strong.

throw it on the floor again

IT WORKS!!!!! YYYYEEEEEEEEEEAAAAAAAAAAA

Try getting a copy of adobe photo shop this might open it just fine. Also try to get a card reader from eather Ebay or radio shack.

I fix all problems all the time on these. what is it doing?
you can also goto www.digitalcamrepair.com and goto the self diagnosis page to figure out what might be wrong.

You error message is your flash circuit which need to be replaced they run around 30 plus dollars for the part or it could be the main board just depends. With out diagnosis it it is hard to really tell.

You can get one off of ebay or order it directly from sony.

Mine is a bit different- Mine turns on to the opening "Cybershot" screen, opens and shuts about 6 times, and then says "Please shut off and then on again" or something. AAH!! Im a photographer! HELP!

Lens mechanism is damaged in your camera. Does lens pops out and in your camera? If yes, try to tapp it while lens pops out.

You will have to dismantle again and check your screws allover again.

Thankyou

Check the Manual or the Sony web site to get an understanding of Multi burst You could simply type Multiburst in your search engine. I gather it is a series of individual still s that play sequentially, but check it out.

E:91:01 is error code related to Flash Circuit abnormality. It requires qaulified technician to fix and such person would be available at nearest Sony repair shop.

my camara when I see or viewed the picture same of they are bad with lines and same videos says error and I can't see it

awawawa

in the camera setup menu you have to have the time and date stamp turned on before you take the picture. Once you turn this feature on all of your photo will have time and date stamps. unless you turn it off.hope this helps

ok there is no master reset for the CCD any how take the Old CCD from the other lens and put it on the new lens make sure the ribbon cables are straite in the socket and you should be good to go. hope this helps if you need any more help let me know goto www.digitalcamrepair.com for more help.

Goto www.digitalcamrepair.com and goto the self diagnosis page to get more info.

Get services and turn it on an don..:P

Your lens assy needs replacement, thanks

I don't think any "cleaning products" will help or be a good idea. If you can use a brush or a sliver of paper (NOT tissue!) and work around the button, that may dislodge anything rubbing or stuck against it. Perhaps only disassembling will allow it to be cleaned properly. If you've spilled Coke or the like on it then that is very sticky (sugar) and it would need to come apart.

You may have a damaged lens mechanism. This happens most often due to some shocks received by the camera. This problem will require service assistance because a lens mechanism is a VERY delicate equipment that needs calibration and proper tools to work with. The single thing you may try is to press back the lents using 2 fingers, one at each side, aplying equal pressure. Don't force them too much however if you see they don't want to get back. Turn on, then off the camera and while it tries to do the same job, give it this ..help. You will hear a click sound when the lens come back in. This works for about 30% - 40% situations, but it depends on the type of damage the camera suffered.