20 Most Recent Pasquini Livia 90 Espresso Machine Questions & Answers

If you are local to us perhaps in Orange County, CA we can provide service. If not you may contact Pasquini to get a local certified repair location near you.

As far as the pressure steam valve goes, you most likely simply need a new o-ring kit... we offer kits for new and older units. Older machines would use Part# KSWV-2 for $5.40, newer units would use Part# KSWV-2 for $4.30. I could explain how you could do this service yourself.

My experience is working over 10 years at Pasquini as a master technician running the home repair sales and service center.

I stock all Pasquini parts for any service of your Pasquini espresso machines and grinders. Contact us for any of your Pasquini sales and service needs.

Sounds like the pressure switch is not working properly and the safety is turning the machine off. Try checking the tube from the boiler to the pressure switch that might be blocked, if not then the pressure switch needs to be replaced.

Hi
there are a couple things you might try. There is a screw in the top of the pressurestat. Turn the screw counter clockwise to lower the pressure.
The light should go off just before the 11:30 position on the gauge.

There are 2 probes on top of the boiler that needs cleaning every so often. A yellow and a green wire connect to the top of the probes. Loosen the small nut about 2 turns or all the way out.
Then pull on the probes to remove then. Sometimes it comes out with the white seal. that is OK. Clean the bottom of the probes and then reinstall.
Yellow goes on the left and green on the right.

The only thing they will do for you is tell you to buy a new keypad for the machine.

Hi I have one that I wrote if you want it. Send me your e-mail and I'll sent to you.

The problem could be calcium built up blocking the jet and stopping the flow of water through your 3 way solenoid valve.
Otherwise the 3 way solenoid has stopped working. The 3 way valve part #91004 is $105 + shipping.

If you capable of removing the top and 3 body side of the machine, you can contact me and I can walk you through diagnosing if this is the problem with the jet or the valve. Before you call, make sure you have a philips screwdriver, 14 and 15mm open ended wrench or crescent wrench, flashlight, and paper clip.

My experience is working over 10 years at Pasquini as a master technician running the home repair sales and service center.

I stock all Pasquini parts for any service of your Pasquini espresso machines and grinders. Contact us for any of your Pasquini sales and service needs.

Try eSpares some are alike in side may be its not worthy to fix

I know this is an old post but I have the same issue and need to replace the transformer. How to get in touch with Tyler di Giovanni? Can't seem to find contact info ;(

See user's manual, if any hint. Actually, didn't know that asquini Livia 90 Espresso Machine has a touchpad. Looks a really interesing device! https://www.seattlecoffeegear.com/assets/user-manuals/pasquini/pasquini-moka-grinder-user-manual.pdf

I found something on amazon, click here and take a look: Amazon com pasquini livia 90 parts. I hope this was helpful. Cheers

Try http://www.cafeparts.com/ or http://www.1st-line.com Parts of Bezzera BZ02 or BZ99 are also suitable for Pasquini Livia 90. They are essentially the same machine inside.