Top 20 Maytag Neptune MDE5500AY Electric Dryer Questions & Answers

Sure I will help you when that happens that means that your heater core is no longer operating and when the heater core doesn't work when your dryer doesn't heat up anymore so that's your problem I hope I have helped you please leave a response or Stars if I have helped

Main Control Board 33003028 Is this the part you replaced?

near fan blower ,had a fuse white by pass than try if work change it than clean the vent

the female is the switch! you can pop the top off and check with electric tester on ohms, make sure you unplug the drye check the breaker make sure you have 220 volts a in the outlet !

Looks like your drive motor is locked up. It has an internal overload switch which cuts power off when motor gets too hot...Replacement of the motor on a used dryer is probably not the best choice as it can be quite pricey..

Disconnect power or turn breaker off for about 5 minutes. This may reset the unit. Otherwise you have an eror showing and need to retrieve the error code. Google your make and model followed by error codes a d you should get a link to retrieve the codes.

This may be from a key that is stuck on the panel. Press each key individually to see if all of them move up and down.

on board fuse or control card cooked

sounds like its hung in a loop unplug wait a few min. plug back in

It might be the thermal cutoff switch. You could go online to see where it is located for that model dryer and have that tested.

Type Maytag Neptune push pad into YouTube and see if the video comes up, thanks!

Have you had a power surge or power go out when the machine was running-----electronics go coo coo when this happens---it may be resolved by unplugging the dryer for a couple of days---then plug it back in & see if it does it again----another issue if the electronics get wet some how roof leak spilled water/fluid--hose replaced on washer which is usually next to the dryer---also check your owners manual to see if this is an issue do to a malfunction of electronics sending a code to check for an issue--that's all I dream up for now--sorry I couldn't do better

unscrew all the panels and clean everything with bleach and soap,clean it outside so you can use a hose,soak it down,let it sit without the doors on for a few days in the sun

unplug it for awhile. Then google " Maytag Neptune MDE5500AY causes for beeping" . Click on appropriate link, and follow what it says

The relay for the motor is stuck closed on the control card. Get a new board from local supplier.

I could be all wet with this but have you check the switch on the door see if it's stuck----also the answers given before are good replies----do you have a schematic?----you've replaced the mother board so depending that's not faulty it should work or you've eliminate one issue---what ever sequence follows the events that start the dryer----by more info--- is the drum turning??----is it turning and your getting no heat----another issue which may or may not be the case is polarity via house wiring----have you had any recent issues with your wiring----wire changing and or service entrance---utility pole replacement----storms---lightning---these are things that can drive electronics nuts with out knowing it---this is all I can think of at the moment---get back to me with more info if you can

Check the wiring then the heating element.

http://www.fixya.com/answer/answerpageslideview.aspx?thid=25326630 Let me know if this helps :)

88 is diagnostic mode. just press cancel or push power again. that will reset it back to normal use.

Pf shows a power failure hols the stop clear button and it should work again.As for your other problems I will more details such as a model number Gas or Electric dryer and example of the problem in detail