20 Most Recent Maytag MZD2766GES Side by Side Refrigerator - Page 2 Questions & Answers

Make sure the condenser is clean and clear, and all fans are working as they should. Also check the freezer section for signs of ice build up. A good defrost and a cleanup usually does the trick! If it's in direct sunlight, try to limit the heat with a blind.

If you've got wet spot on the passenger side floor area, it is *probably* a leaking heater core. If the wet spot is an antifreeze / water mix - it is almost certainly a leaking heater core, since it is located behind the dash in this area. A leaking heater core problem can be expensive to repair - as it is difficult to access. Replacement drives the price higher still.

If is is fresh water, it may be a leaking windshield seal. An auto glass shop should be able to fix this for you for a lot less than the heater core repair.

I hope this helps and good luck!

The touch pad is not avail separatley, the conplete Facade/Escutcheon needs to be replaced. Part# 61005386 approx $160.00. In some cases the original clear plastic protective film might still be left on the front of the facade. Pleazer Appliance...

From your description it sounds like the start components (start relay, overload and capacitor) are having problems. The clicking you hear is probably the overload kicking out to protect the compressor. It is quite possible that the compressor simply has gotten too hot and after sitting a while will restart when plugged back in. The start components are not generally considered 'user serviceable' parts. When the compressor has cooled to pretty much room temp, plug it in and be listening for those clicks. If you hear them, unplug it because it could eventually damage the compressor. Those components give the compressor an extra jolt to get the compressor running then they drop out of the circuit. If the compressor doesn't start, it creates heat until the overload drops out.

If the insulation in the door has blown, it cannot be replaced. If there is a dispenser in the door, look at all the plastic parts for any splits or leaks. To test if it is the dispenser, turn off the water supply for a few days. If the water stops collecting in the door it's a good sign.

Is your compressor giving sounds like a buzz followed by a click periodically? Is the compressor exterior warm/hot? Most likely the compressor start relay assembly is bad, or the compressor is locked up, (frozen internally). If you connect an amp probe to the red wire of the compressor, and the momentary reading meets or exceeds the LRA rating on the compressor tag, most likely the compressor is at fault. Pleazer Appliance...