20 Most Recent Maytag MMC5000 Microwave Oven - Page 6 Questions & Answers

Chances are you have an issue with a door switch or door switch mount. See my help files here: http://www.microwavecontrol.com/safety.htm http://www.microwavecontrol.com/disassembly.htm http://www.microwavecontrol.com/doorsw.htm If you need further help, e-mail me through my Web site (above) with your full model number and detailed symptoms.

Maybe on control panel or inside door.

If you have a stargate chassis maybe look near the power cord, and least they are not on the Antares board of my buggy AKZ 430 : Whirlpool Oven AKZ430 goes to F03 mode in couple of minutes even after...

Find your model's support page here: http://shared.whirlpoolcorp.com/product_literature/search_results.jsp?searchTerm=&siteCd=WHRCOM&userType=Consumer Then enter your full model number in the "Search again" box.

https://www.repairclinic.com/UserManual/75608c343f8549028da3cf6e0814364c/Maytag-Microwave-Repair-Manual-MMV5100AAB-MMV5100AAQ-MMV5100AAS-MMV5100AAW.pdf

Microwave ovens often have a 12-hour clock and have no need for AM/PM.

Does everything else work?? If so, its just the turntable motor, simple to replace. there are three or four screws under the bottom. UNPLUG the microwave first. Double check before ordering...but .. Here is the one you need: Turntable Motor DE31 10172C

Your touch pad is connected to your board with a ribbon wire, it has probably come loose. Unplug the unit and remove the face plate. Pull it back and you will see the wire, it looks like a ribbon, push it in tight, replace the face plate and it should work properly. I see this happen all the time.

unrepairable unit junk it

Check this site for parts you are talking about. Search Over 2 1 Million Appliance Parts

Try a hard rest of the electronics to restore unit to factory defaults. If that does not do it your logic board has failed and if not too expensive you might want to replace it. Check it out at site Search Over 2 1 Million Appliance Parts

Probably a bad mag, if the transformer goes bad it will draw a lot of amps and blow the fuse. If a mag shorts it just makes a more pronounced hum. Same with the rectifier. If you Ohm out the rectifier it should show open both ways as it is a really high resistance and the only way it would make a louder hum is if it shouts. so If it looks open it is probably OK, and probably bad mag. .