20 Most Recent
Konica Minolta bizhub 250 All-In-One Laser Printer - Page 6 Questions & Answers
Jumping paper in regaster rooler
Open the right side door and check for proper insertion of Paper dust remover beside transfer roller. Not proper inserted Paper dust remover cause paper to jumping register roller.
Konica/Minolta biz 350 C2557 after replacing DV unit and drum F8
tha minolta di3510 developer unit looks the same as the unit for the konica minolta bizhub 350 but the toner sensor in the minolta unit uses a different voltage range for the toner sensor and it will throw this code make sure you have the correct unit for this machine also you can try this go back into tech rep mode and change these settings:select tech rep choice modeselect printer tabselect atdc sensor gainset the value to about 165then back all the way out to the ready screen and power the machine off then back on and replenish toner in the user management screen.
Konica Minolta CF3102
If it is the Admin password that is needed to be reset you CANNOT! You need to find out what it is to change it.
Printing color problem
you need to place a service call, it sounds like the imaging unit is need or replacement
Smtp authentication - bizhub 250
Firmware can be upgraded by using a 256mb compact flash memory card.
The slot is located on the right side of the machine below the scanner glass. Its in the same area where the fax phone lines plug into.
Minolta EP 3000 code M1
Main motor failure to turn. Check the drum and the developing unit is it is rotating easily.
Reset your Toners and Imaging units for Minolta Bizhub and CF series.
http://www.chipreset.eu
Bizhub isn't turning on
It can be the problem with the power supply or with the Print control board,Remove the back cover and see cables.Mice likes the smell of those cables.
Not finding what you are looking for?