Konica Minolta bizhub 350 All-In-One Laser Printer - Page 3 - Answered Questions & Fixed issues
C-3904 bizhub 500
do this once only. If the code comes back then the fusing unit the hot part is broke, it could be a thermistor, heat fuse, heat lamp or the board that controls it. Have a tech look at the fuser? Do not continue to reset or a fire could occur and that would ruin a perfectly good day :) Code is for the FUSER!!!! (HOT PART)
1. Turn ON the main power switch (SW1).
2. With the Utility/Counter key pressed, turn ON the power switch (SW2).
3. Press [Trouble reset] to release a trouble with [OK] displayed.
4. Turn OFF and ON the power switch (SW2). Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
C3451
Sir/Mam,
On the right side of the machine just below the scanner section (The part with the big glass) is a cover next to where you connect the Ethernet cable. Remove the cover, with the machine on use a small screw driver and gently depress the small black switch. The machine is going to go thru some screens when you see the screen with the copiers on it to the left on the screen in the middle you will see a "." when that is displayed press 3. The code will come back but now press the Utility/Counter button, you should see a button that says Maintenance Mode press that, see Trouble Reset press that and the machine will again will go thru warm up procedure, you will see the "." DO Nothing! The machine should go to "Ready to Copy" if the code comes back. Have a technician look at it DO NOT CONTINUE TO RESET the code is for the Hot Part called the FUSER. It can catch on fire! And that will ruin a perfectly good day!!!! Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
C 0001 code on Konica Minolta bizhub c350
Main Motor, recommend that you remove all of the image units, shake each one along its axis so that the developer in each unit is evenly spread across the units, so that not all the developer is sitting at one end, DO NOT STORE IMAGE UNITS UP and DOWN always lay flat. Might have already burned out the motor worse case the control board$$$$$$$$$$$$$$$$$$$$$$ Btw, I’m available to help over the phone in case u need at
https://www.6ya.com/expert/normanj_7893313f0751935f
Not finding what you are looking for?