20 Most Recent AEG 23 in. Favorit 44070Vi Built-in Dishwasher - Page 8 Questions & Answers

The problem when the dishwasher does not heat is failure which requires to remove the qualified personnel and therefore error code is not shown on the display but it is visible in the service mode. Possible error causes: faulty heating element wiring between heating element and PCB PCB (printed circuit board) Dado

It is possible, but definitely before check if something is obstructed or blocked the drain pump. Error "i20" means there is a problem with draining water. Dado

The most common cause of a fault "i10" is closed valve on the water supply line. So this failure indicates a problem with filling of water. Possible error causes: Closed water tap, Inlet valve faulty, inlet hose bent, softener system clogged, pressure switch or pressure switch hose obstructed or leaking, wiring from pressure switch to printed circuit board (PCB), wiring from inlet valve to PCB and finally PCB. Dado

Error "i30" means that water remains in base because leakage or overflow. In this case, in order to prevent flooding, drain pump running continuously. When we talk about AEG dishwasher, drain pump works even the power is turned off (must be connected to the wall outlet, otherwise anti-flooding system will not work). The noise what you heard during operation indicates that something is blocking the drain pump. Remedy: you should first remove the water from the bottom of the dishwasher and determine leakage then check why the drain pump makes noise. If you work around the dishwasher, you always take care that appliance must be disconnected from the power supply. Good luck. Dado

check that the screw is missing probably fallen in to the filter

have you tried cleaning you filters. this sometimes stops the machine from draining

Fault is associated with cylcling pump which pumps the water during washing. It sounds like it is only happening occasionally which could mean that the control board for cycling pump is faulty. If happening every time then pump may be faulty. This parts can be pretty pricey so if its only happening occasionally then you may want to consider living with it until it gets worse.

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/

Should be in the manual.

whats the make and model. maybe something from on of the inside soap door area cant look up diagram without the make and model .will try ok

there has to be a short in the wiring check and make sure that the wires are connected correctly "White to White, Black to Black and Green to Green the green is the ground"