20 Most Recent AEG 24 in. Favorit 60870M Free-standing Dishwasher - Page 6 Questions & Answers

Second opinion by technicians, and not only guesswork referred on fail codes Only the costs of driving and the sale of two modules is shortsightedRefer to the service manual search tree base error voltages consult measured from beginning the power supply. refferent with the points in the service manual, check out the right model and revision of the right parts (such as AEG model 88060 (IM IB or other gain after the model number. It is very important to have the real serial number of changes to the revision know the model marketing technical differences because they are not excluded. in reality dirt and moisture can be have caused its influence by the time various microswitches,slnd valve or sliding contacts or soldering or loose parts in the circuit board can even just sit a leaky capacitor which topped convex or deformed.That are other suggestions Because The fault can be not allways based on only the both SMD prints but a component or 1 of the circuit boards or a wire or only just a resistor. It may be known by the mechanics but it is still a major cause of error for the mechanics may prove that it is a defective product and still guarantee (fairness) decision must be hidden defects if he's just out of warranty

There is a problem with drainage. Check the drain line connected to the disposal or peatrap. Make sure it is not plugged. Otherwise you can disconnect the drain line and put a wet vac on it to try to clear the hose

i20 error code means: Water is not pumped off and could be:

• Fault with discharge pump

• Discharge pump deenergized (faulty wiring or no activation by electronics)

• Obstruction/blocking (filters in the appliance, discharge opening in discharge trough, discharge pump, discharge hose, siphon, cover plug at siphon connection not removed during first commissioning)

• Discharge hose bent or connection height above 100cm

• Ball valve in discharge trough glued / blocked (discharge pump does not aerate)

or water level inside appliance is not detected and than could be:

• Pressure controller faulty

• Pressure controller hose obstructed or bent

• Insulation fault with heating element

Dado

Hi Glen Searched the internet & found this Appliance Parts Online Appliance Parts for all Household Brands All depends what country your in and who the local supplier is. Or Buy it on line for eBay or AliExpress.com or Deals Extreme https://login.aliexpress.com/buyer.htm?return=http://www.aliexpress.com DealeXtreme Cool Gadgets at the Right Price DX Free Shipping Worldwide

Electronic is protected against short circuit throught out VDR - voltage dependent resistor which is located on the electronics. Unfortunately, when this happens usually get hurt some other component part or burn printed circuit boards. Any intervention on electronics requires qualified person otherwise there is the risk of fire or electric shock. Dado

Maybe ereplacementparts.com

Heater, 230V./2000W.-d.32mm. The heating element, which is encased inside a tube, is used to heat the washing water. The heating element is not activated during the drying phase. Inserted into the delivery side of the washing pump and coupled with the duct which directs water to the upper spray arm. Built-in safety devices: Two thermostats First thermostat: auto-reset bi-metal thermostat calibrated to 98°C and connected in series to one branch of the heating element. Second thermostat: manual-reset fuse calibrated to 206°C and connected in series to the second branch of the heating element. If this fuse intervenes, the heating element is disconnected definitively. Dado

I think it is best to connect power cable directly to the interference filter where is normally connected.The interference filter is connected in the terminal board parallel to the mains feed. See below pictures: Dado