20 Most Recent
- Page 5 Questions & Answers
Hi I have a AEG favorit 88060 dishwasher with i20, ico and 15 fail codes. I had AEG come out to take a look and the suggested changing both PCB's and the wiring between the 2. Has anyone any advice?
Second opinion by technicians, and not only guesswork referred on fail codes
Only the costs of driving and the sale of two modules is shortsighted
Refer to the service manual search tree base error voltages consult measured from beginning the power supply.
refferent with the points in the service manual, check out the right model and revision of the right parts (such as AEG model 88060 (IM IB or other gain after the model number. It is very important to have the real serial number of changes to the revision know the model marketing technical differences because they are not excluded.
in reality dirt and moisture can be have caused its influence by the time various microswitches,slnd valve or sliding contacts or soldering or loose parts in the circuit board can even just sit a leaky capacitor which topped convex or deformed.
That are other suggestions Because The fault can be not allways based on only the both SMD prints but a component or 1 of the circuit boards or a wire or only just a resistor.
It may be known by the mechanics but it is still a major cause of error for the mechanics may prove that it is a defective product and still guarantee (fairness) decision must be hidden defects if he's just out of warranty
on Jul 27, 2016
Not finding what you are looking for?