20 Most Recent Whirlpool RBD275PR Electric Double Oven - Page 6 Questions & Answers

try Cutting power to unit at breaker box for 5 minutes. This may reset electronics

SAFETY THERMOSTAT MAY HAVE TRIPPED. MOST ARE LOCATED BEHIND THE REAR SERVICE PANEL. THERE SHOULD BE A WIRE DIAGRAM, USUALLY ON TOP OF THE OVEN IN A POCKET, IF THE THERMO IS OPEN, WILL HAVE TO BE REPLACED & OVEN WOULD HAVE TO BE CHECKED FOR ACURACY.

You didn’t leave a model #. It depends if Door Lock is electric or manual.

Unfortunately, the F1E1 error indicates a EEPROM checksum problem with the control board. An internal check for the board gave a result that didn't match the one that is stored in the read-only memory. The only solution is to replace the electronic control board for the stove. Please add a comment with the model number of the stove if you would like to know if this control board is still available and the price for it. Cindy Wells

It should be spelled out in your owners manual.

When the power drops, it often sends a spike down the power line. Most electronics are sensitive to voltage spikes and if too high, destroys the equipment. Unfortunately your display is probably toast.

Most likely control / display needs replacing

Oven temperature sensor most likely has failed.

Try asking the store about it. Maybe it's a privacy setting you need to turn on(or off)

Probably bad bake element

I had that b4 and it was the ribbon cable. Disconnected and reconnected and was clear after 60s reset cycle.

I had similar issue with my electric stove as well. The model of the stove is the same as the one that us mentioned above on the beginning of the this discussion. The issue I had on my stove was that the display shows time and no error code how ever the oven top light indicator comes on but the oven won't heat up. Here are the steps I took to fix the issue: First I unplugged the stove and used a multimeter to verify that it has 240Volt coming. It checked good for 240v. Second, I opened up the terminal on the stove where the plug connects, there I discovered one of the hot leg has melted and broken thus only 120v getting to the stove. I repaired the broken wire and verified 240v coming in the stove and stove was fixed for good. I further investigated what caused the wire to melt and broken, my finding was exposed hot wire shorted to the stove body (ground). Hope this helps. Thanks for reading

use a quality oven cleaner and do it the hard way as the self cleaning is not working

Wiring most likely is incorrect at thermostat or board.

I can try it again

Have you tried to reset it ? If yet then I may be reprogrammed: Whirlpool Oven AKZ430 goes to F03 mode in couple of minutes even after...

You may have a damaged oven control panel. Contact your local utility and file a damage claim

The likely problem is that the oven control panel is burned out.

Fix it because it need repair

Go to this link on the ukwhitegoods forum http://www.ukwhitegoods.co.uk/forumsphpbb3/cooker-oven-forum/switch-whirlpool-generation-2000-oven-t35121.html