20 Most Recent Whirlpool Duet GHW9150P Front Load Washer - Page 9 Questions & Answers


will burn the seals out .

Whirlpool Duet... | Answered on Dec 27, 2015


this is the code list I found with what you posted

Whirlpool Duet... | Answered on Dec 13, 2015


try unplugging it for about 10 minutes and then plug it back in and see if the error dosent correct itself.

Whirlpool Duet... | Answered on Dec 02, 2015


To unlock the control lock press and hold the cancel button down for 5 sec or till you here a beep.

Good luck

Whirlpool Duet... | Answered on Dec 01, 2015


Locking controls
The Control Lock prevents unintended use of the washer. You
can also use the control lock feature to prevent unintended cycle
or option changes during a cycle. When CONTROL LOCKED is
lit, all buttons are disabled. You can lock the washer while it is
operating.

To lock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds.
The CONTROL LOCKED status light glows.

To unlock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds until the
CONTROL LOCKED Status light turns off.

Whirlpool Duet... | Answered on Nov 16, 2015


I have the WFW9150WW00 whirlpool duet, I start the cycle and it starts to wash and then starts beeping, I push the start button and sometimes it will finish the cycle fine and other times it will just shut off like it is done and clothes are dripping and has never finished the other cycles. What is wrong

Whirlpool Duet... | Answered on Nov 03, 2015


drum bearings are gone,it would cost too much to repair,the drum shaft would to be repalced as well.Sorry

Whirlpool Duet... | Answered on Oct 21, 2015


yep, I have that problem too. My son's winter coat got wripped to shreds.

Whirlpool Duet... | Answered on Oct 15, 2015


call a repair shop we have no idea here on FIXYA

Whirlpool Duet... | Answered on Sep 27, 2015


Your soap tray and/or inlet is probably blocked with undissolved powder. Remove the tray and clean it. Also clean the inlet tube from the tray into the washing machine with hot water.
I, personally don't like soap powder and use a liquid or tablets because washers nowadays tend to use cold water only so doesn't fully dissolve the powder. Also the outlet to drain gets blocked along with the underground pipe to the mains sewage.

Whirlpool Duet... | Answered on Sep 25, 2015


If it's the same as a UK version, F6 is a motor speed sense fault

Whirlpool Duet... | Answered on Sep 21, 2015


take the soap draw out there should b a sign on the draw to press also the top of the sofner compartment comes off u will see a hole where the water goes make sure it is clear put the lid back on hold soap tray under water tap let the water fill the sofner compartment it shoud run out

Whirlpool Duet... | Answered on Sep 08, 2015


Pull the mains plug and count to 10. Replace the plug and start again. This resets the computer board, and you will be able to open the door and start again. It happened to me once :>)

Whirlpool Duet... | Answered on Aug 31, 2015

Tip

Hoe to unlock the controls of whirlpool washing machine


  1. To unlock the controls: Press and hold the End Of Cycle Signal button until the Control Lock light goes Off. To lock the controls: Press and hold the End Of Cycle Signal button until the Control Lock light comes On.

write_tip-sap4owyfpomquw3pehjkxnse-3-0.jpg


write_tip-sap4owyfpomquw3pehjkxnse-3-2.jpg

on Aug 24, 2015 | Whirlpool Duet GHW9150P Front Load...


Hi


The light is flashing due to the door lock error. The door lock is activated as the machine experienced an error or was stopped in middle of a cycle. Or the door was being pulled while the machine was running a cycle. Try unplugging your washer and restart the washer to check if you are still getting the same blinking light. If error is still not resolved then start the rinse/spin cycle & stop the cycle, now press and hold the cancel button for 5-10 seconds. However, if you are still not able to get the door open then you'll need to open the door manually by disassembling the washer. Please post back for any further assistance.

Daniel

Whirlpool Duet... | Answered on Aug 22, 2015


This is a common and easily fixed problem. The door should NOT be opened after the wash is completed. You have to wait for AT LEAST 2 minutes to try the door, do not use force. There is a built in mechanism for most front loaders to delay the door opening, so be patient.
In your case you might have already damaged the door lock, so replace. You are lucky if the door can be opened after the lock sign goes off - otherwise you just have to change the door lock.
Click if helped.

Whirlpool Duet... | Answered on Aug 21, 2015

Not finding what you are looking for?
Whirlpool Duet GHW9150P Front Load Washer Logo

11,377 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

jimorris77

Level 3 Expert

411 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

duet Whirlpool

  • duet Whirlpool

Most Popular Question

whirlpool duet washer after problem

  • Washing Machines
Loading...