20 Most Recent Whirlpool Duet GHW9150P Front Load Washer - Page 3 Questions & Answers

whirlpool duet dryer has power but will not start--when I press start, it beeps once and the sensing light comes but the dryer doesn't start

Whirlpool Duet... | Answered on Dec 06, 2017

I would get in touch with a washing machine repair person as I believe what you may have either a bearing disintegrating or the spider, the contraption that holds your drum horizontal and allows it to spin,may be corroding. It's called a spider, it's aluminum, and it's got only three legs but when those legs break, the plastic drum and other expensive things often suffer damage as well.

We had this experience this spring with an Inglis washer which is a sister set to the Whirlpool Duet. If the spider is corroding or a bearing is going, and changed before it breaks, it will likely save you about $600 on your repair bill. Remember to compare any repair cost against the cost of a new unit including the age difference. Washing machines only last 7-10 years now... they just aren't built like they used to be.

Whirlpool Duet... | Answered on Nov 29, 2017

Unpluggin the machine is pretty much the only way to reset it.Leave it unplugged for a couple hours if that doesnt work its most like a control board issue

Whirlpool Duet... | Answered on Nov 27, 2017


Whirlpool Duet... | Answered on Nov 17, 2017

This could be the belt on the drum has broken or come off. It may also be the door latch switch is loose or broken.

Whirlpool Duet... | Answered on Nov 13, 2017


Whirlpool Duet... | Answered on Nov 05, 2017

better call the manager and have them look into the problem . FIXYA can not get there to do it for you

Whirlpool Duet... | Answered on Oct 30, 2017

Water up to door level means your motor and motor control unit (MCU) was covered with water. Most likely your Motor control unit (MCU) is damaged rather than Central Control Unit (CCU).

Listen, you have to buy a new machine. If you end up putting CCU and MCU both into a soaked wash motor washing machine, you will be so mad with yourself.

Time to go to Home Depot looking for a new machine.

You use that flooded machine then all your washing machine warranty and liabilities from the manufacturer is out of the door. Even your home insurance may not honor if you knowningly use a flooded machine and something goes wrong.

Whirlpool Duet... | Answered on Oct 26, 2017

Sounds like a valve isn't closing properly. I would suggest you call for service.

Whirlpool Duet... | Answered on Oct 24, 2017

Just take off the bottom kickplate (3 screws on the bottom). You'll see the pump front and center. Twist the front face of the pum slowly to the left. All the trapped water will flow right out towards you. There could be a sock or some other debris there. Unclog, screw that faceplate back in and start it up.

Whirlpool Duet... | Answered on Oct 18, 2017

there either is a rust mark on the tub or under the agitator oil could be leaking out or metal is rotting where the tranny shaft comes up under the agitator but like you said it's old and parts are starting to rust out and decay

Whirlpool Duet... | Answered on Oct 07, 2017

Not finding what you are looking for?
Whirlpool Duet GHW9150P Front Load Washer Logo

11,377 questions posted

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts


Level 3 Expert

85223 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers


Level 3 Expert

411 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

duet Whirlpool

  • duet Whirlpool

Most Popular Question

whirlpool duet washer after problem

  • Washing Machines