20 Most Recent Cannon MULTIPASS C530 Printer Questions & Answers

please help where to download driver for pixma iP1700 i needed badly

Hi,
Download the drivers from this link. Make sure you select the driver that corresponds with your operating system.[XP,VISTA MAC etc]

Hope this helps.Thanks!
Please rate this answer.

Download the driver from the link below. http://www.usa.canon.com/cusa/support/consumer/printers_multifunction/multipass_series/multipass_c530 Regards GM

Hello;

This mostly occurs due to some paper quality.

* Try replacing some different Quality of papers
* Try cleaning the Heads of the printer through the maintainece software provided by canon.

I believe what you are seeing is "WASTE INK TANK FULL"? This means that the tank that collects the waste ink from cleaning the head is full. You can read more than you ever want to know on this subject on the following link: http://www.fixyourownprinter.com/forums/printer/38697#1 These are the steps to clear the message by reseting the counter: 1)Printer on, press Additional Functions, Scan, Copy, Scan Now you should be in service mode from there for waste ink tank reset 2)Select Test mode which is like the last available selection 3)Select #8 Printer Test, it will do something here like cleaning or something then it will come up with some other options this is where it gets a bit confusing cause now all it says is like 8-2 or 8-3 push the + or - button until it says 8-3 then hit the select button The menu will now say EEPROM Clear Select Ink count which is option (0) and press set Your done!

if you ever get this figured out, let me know, my mp730 says the same thing, i had the head cleaned after i got a wrong cartridge error and now i have a put in cartridge error

Try going to the canon website www.usa.canon.com then update the firmware of your printer

Peel too many apples for a Thanksgiving pie, and the "waste" (the apple-peels) will fill your garbage-bin. So, you have to empty-out the garbage-bin, or replace the full garbage-bin with a brand-new _empty_ garbage bin.

Print too many pages, and the "waste" ink will fill the miniature waste-bin inside the printer. Take the printer to a qualified technician, and have him/her either empty the bin, or replace the sponge in the bin with a fresh sponge.

Ok i know where your answer is
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=SupportDetailTabAct&fcategoryid=238&modelid=9526

This is more than likely a ink cartridge failure. If you are using after market/or refilled ink cartridges, I would try an OEM cartridge to clear the problem. The non-OEM ink has probably clogged the nozzle.
Change the cartridges, run a deep cleaning on all colors, run alignment and the test page. The problem should clear up.
Sometimes non-OEM inks are not up to specifications and cause this problem.
Let me know if this clears the problem.
Please make sure to rate this solution. Thanks.

You take out all the cartridges, then raise the leaver on the left and side of the carrage that the ink cartridges sit in with one hand, and you will find that you can gently lift out the print head with the other hand. Quite easy really. Why do you need to get it out?

You can pull out each cartridge and shake it gently to redistribute the toner. Try a half page test to eliminate the various stages of the image formation. The timing on this is not easy but through trial and error it can be helpful.

you need to clean your heads

If you do not have the disk you must download the software from Internet, follow instructions below,

Click here:PIXMA office all in one inkjet printer

A web page will open, follow instructions, select model, select operative system etc., and click on download .
Chose to download the file in my documents when asked.
After downloading, find thefile, double click on the file , then if you get in troubles,follow theinstructions below to reset and reinstall drivers:

• Unplug printer USB.
• Go to control panel >> installed printers in Windows and remove (delete ) any installed printer from printer list.
• Download driver from website, or use the disk and run the install file.
  
• Follow driver installation wizard.
• Plug back printer when prompted from installation wizard.

Note:some printer does notwork on Vista, if you do not find any driverdownloadfor Vistaonyourmodel page, that means your model is not Vista compatible.

Hi shortiered,

Sounds like your orginal driver installation has become corrupted. Try this: completely remove unit and its software from your computer, not forgetting to unplug all cables. Go to the folling url(copy and paste in the address bar) for the latest software for your unit. It's easiet if you create a new folder on your desktop and name it mp530 drivers, save down load here. Install software first, reboot and plug your cables in, windows will reconize new hardware and install it for you or it may ask if you have installation disk or installation file, click yes and direct download to the folder you created for your new drivers. I hope this helped a little, if not, hit me back, we have other options.

Thanks for using FixYa.com

Sincerly, cyyyd7


http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&fcategoryid=123&modelid=13371#DownloadDetailAct

Go to
http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=DownloadDetailTabAct&fcategoryid=334&modelid=7997

Scroll down to "Guides and Manuals" and select "MPC530 and MPC560 User Manual"

Label_Guy

I do not have a cd to install printer, what do I need to do

Download the software from this link:

http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=DownloadDetailTabAct&fcategoryid=334&modelid=13371 I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Download the manual from here:

http://www.usa.canon.com/consumer/controller?act=ModelInfoAct&tabact=DownloadDetailTabAct&fcategoryid=334&modelid=13371 I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309