20 Most Recent Plantronics - Bluetooth Headset Plus Base & Headset - Page 2 Questions & Answers

Another bang bang solution...

Be sure to charge your headset for atleast 15-25 minutes minimum to get a starting charge. This will also give you 15-30 minutes of talk time to test out your headset and placement, and also get used to being a part of the bluetooth generation.

Once charged, press the call button(the big button on the side) and hold it down until you see a flashing red/blue combination of lights, now you only have 2 minutes to set this up, or you have to start over.

Once the lights are flashing on the headset, it is searching for a phone, now you go to your phone, and find your options for connectivity or bluetooth, once in your menu, look for the option to search or connect to a blue tooth device. Let it search/connect automatically.

Once it is connected, the flashing lights on your headset should stop, finish the connect process on your phone, if it says found it, install it, entering device data, etc etc, follow everything it says by entering YES, hitting OK, or CONTINUE.

Once it says CODE or PASSWORD to enter for your bluetooth device, enter 0000 .Which is ZERO ZERO ZERO ZERO and then press enter.

It should take 2-10 seconds for the password to initiate, record into your phone, and pair your device. This is a detailed explanation. Please rate me for my effort.

ManOwar

You could try the bluetooth generic passwords (0000 and 1234), these usually work with most devices.

The generic PIN (Which is what I'm guessing you need) for most bluetooth devices is either 0000, or 1234. Please try those and see if that solves your problem.

to pair your Plantronics headset with your phone. Enable blue tooth on phone, push power button on headset and hold (make it flash between blue and red). You then have 2 or 3 minutes to type in the 0000 passcode to sink them. It really does work (tech support from Plantronics told me how to do this).

many are preset from factory at 1111 or 9999 or 0000 good luck

to use the pass code for your blue tooth device you must first put the device into discovery mode then most blue tooth manufactures use a factory 4 digit pin pairing code they are as follows 0000,1234,1111,or 9999. i hope this helps

most blue tooth manufactures of blue tooth devices use a factory 4 digit pin pairing code now the most common one is as follows but there is a possibility that i could be one of the others i will put them in order from most common to least commmon try them in that order they are 0000,1234,9999,or 1111 i hope this helps

http://www.plantronics.com/media/media_resources/literature/user_guides/explorer_390_ug_en.pdf;jsessionid=6A96FBBA24861D3B48288B1EF01302E7.bravo

Most passcodes are 0000 (4 zeros)

Dear,
The most bluetooth devices use 0000 (4 x numerical zero) as it's default code.
Sincerly

first question,i have anplantronics explorer 242 when i plug it iun to charge it the light ired then after a few min. it turns blue,how do i know when its fully charged? will the lights go off?

0000 should do it

Plantronics Bluetooth headsets often use "0000" for the passcode. Does that work with yours?

licence

For most Plantronics products, this passkey is 0000
please Rate me +++++

For most Plantronics products, this passkey is 0000
please Rate me +++++

For most Plantronics products, this passkey is 0000
try , enjoy and
rate me please