20 Most Recent Mitsubishi WD52527 52" Projection HDTV Questions & Answers

The model indicated if unplugged and plugged back should have the green light blink for about 70 seconds and then stop blinking and go out---set is booting up--if it does not ever stop blinking something in Digital area is bad--this was a common problem in these sets and is not a do it yourself repair.

Hello Mr. JohnI don't know to whom you did the payment and went in vein. I've the original service book to your TV; [Mitsubishi WD52527 HDTV]. But I can't send it to you by this window as it does not allow me to upload any PDF files by it, and the document is in PDF format, have two files, with a total capacity of 7.9MB. If you send your email address to me by Fixya comment box, I'll try to upload the document to you for absolutely free. If Fixya bloks me to upload it, there is no other way to send it to you by Fixya itself, Just send your Email ID to me. Let me get a try. OK.

HelloThis is really a problem to some Mitsubishi projection TVs.

This LCD Projection Television uses three LCD panels to create the screen image. This technology creates the image using small dots, or picture

elements (pixels). Your LCD Projection TV is manufactured to a high level of performance and quality, in fact, 99.99% perfect in the number of

properly functioning pixels. As in other display technology, sometimes a pixel is continuously active, inactive or the incorrect color. Our standard is clear; MDEA warrants only that the percentage of properly functioning pixels will be not less than 99.99% of all pixels.This is the company says about this problem. Your set need service care fro authorised service center.

BEFORE REQUESTING SERVICE, please review the instruction booklet to insure proper installation and correct customer control adjustment. If the problem persists please arrange for warranty service

Try website like Tvrepairworld.com have it for $229 Mitsubishi colors wheel.Make sure the same exact colors wheel model as ur tv model ok and u have the skills and know how to do it ur self.These colors wheel are deligate part and can be damage easily.If not sure about it and can or can't do it.Hire a tech. to do it.These colors wheel are spinning at 1200 RMP if u put in wrong the colors wheel 50/50 can be damage the place u buy it from will not take it back.

Replace you lamp again but this time do not use generic lamps or off manufacutred lamps. use Genuine Mitsubishi lamp.

the light bulb needs to be replaced it burned out

I had a similar problem with my 42 in Philips LCD HDTV. Here was the problem. My Power Supply Board had several bad capacitors. I opened my TV (warranty was expired ofcourse) and found four bulged capacitors. Many electronics companies were sold capacitors that failed in 2-5 yearsinstead of 10-20. The capacitors failprematurely due to a lack of preservatives. Unfortunately, they were installed in allsorts of devices. Here are some options for you.
1. Have it fixed by a professional 2. Open your TV and find PSB. Checkfor faulty caps. If you find some (bulgedor leaking) bad caps replace the entire board. 3. Remove and then replace individual faulty caps. This takes some soldering skill. Caps are inexpensive and if you can take care of it yourselfit will save you hundreds. I have a tip/tutorialon this site that may also help. Itgives step by step instructions for replacing caps on PSB #715t2432-2. If this is your board you are in luck. It'scalled: Fixing the Philips Turns/shuts off on its own problem. Hope this helps and Good luck.Kaufman605

http://www.retrevo.com/support/Mitsubishi-WD-52527-TVs-manual/id/276bh928/t/2/
Click on download manual.

The wire you speak of comes as part of the light engine. IT is not a replaceable part. Your best bet would be to contact local repair shop and see if they have one from a scrap set.

I would contact Mitsubishi and see if there is s software upgrade for this model. You can contact them at 1-800-332-2119.
Hope this helps,
Skyassoc

hello my name is rico and maybe i help u with your tv i work on tvs sometimes your problem is two things ither your lamp or cooling system, if you need more help let me know i live in mesa az my phone number is 602-810-7149 feel free to call

Need to replace optical engine block to correct this issue,.

LAMP DOOR LOCATED IN THE BACK ON THE RIGHT HAND SIDE LOOKING FROM THE BACK. IT IS HELD ON BY 2 SCREWS THE LAMP IS SET BACK IN THE TV ABOUT 5 INCHES FROM THE LAMP DOOR SUGGEST A LONG FLAT HEAD SCREWDRIVER TO LOOSEN THE LAMP. INSERT NEW LAMP AND PUT LAMP DOOR BACK ON. THERE ARE INSTRUCTIONS IN YOUR OWNERS MANUAL.

Confirmed case of a faulty color wheel. The hum confirms that the motor that is spinning the wheel is acting up. You will need a replacement color wheel with housing to resolve this problem. Not sure whether you can do it yourself as this is a rather complicated repair though.

Thanks for your question!
I'm sorry that you haven't received an answer yet.
The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:
1. the question is unclear, incomplete, or poorly worded...
2. the question is mis-categorized - so the correct experts aren't viewing it...
3. the question requires an answer for something that cannot be explained online adequately...
4. specific training, tools, or equipment are required to avoid injury or death...
5. the Experts that are online simply don't have the resources to answer your question fully...
Please feel free to re-work your question if you feel one of these may be the reason.
Of course you are not required - but converting your question to a PAID one usually increases the reply rate as well.
Normal rates for FixYa are...
$ 9.99 answer for one question.
$12.99 Live Real-Time online chat or premium e-mail support.
$29.99 Live Real Time phone support
Sometimes FixYa will run specials for unlimited questions via monthly subscription or reduced rates for limited periods.


Consider the savings that can be had when an informed Expert can save you a $100 service call, or a $350 trip to the car dealership.
Your problem solved - guaranteed! Or your money back!!

If you don't want to pay - feel free to re-submit your question so it returns back to the top of the work queue if you still need help.

Thanks for using FixYa - a 4 THUMBS rating is appreciated for helping with your FREE question

Hi , it seems you are experimenting a light engine problem.Here's how your tv works: http://www.youtube.com/watch?v=ZLLHnQ4y-wo Basically there's 3 LCD chips that create the colors and image by blending together.When these chips start to melt you will get those blue spots, pixilation even vertical lines.You will need to replace the light engine replacing the bulb will not solve your issue. Have a blessed one!