20 Most Recent
Hoshizaki Freezer Commercial Ice Machines - KM900MRH Commercial Ice Machine - Page 2 Questions & Answers
Ice machine is on, but
this could be a large range of issue and too many to list for someone who may not be a skilled technician. I strongly suggest having a tech check it out as it may get into removing freon or more to make the repair. Sorry for the news.
6/17/2017 11:12:54 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
Why does my KML-600MAH only make water not ice?
Check to see how long it stays in the freeze cycle. normally it takes a least 20 minutes to make a batch. If less than that, you are probably loosing water causing an early harvest and almost no ice.
6/17/2017 11:08:35 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
HOW DO YOU CHARGE R404 A SYSTEMS REFRIGERATION
First question, why do you need to charge the system? Second is it a remote unit or self contained. Third do you have a set of refrigeration gauges? The best wau is to weigh the proper charge into the machine through the gauges. That varies depending if you are air cooled, water cooled or remote.
4/6/2017 1:21:25 PM •
Hoshizaki...
•
Answered
on Apr 06, 2017
2 problems one water escaping
first, freeze cycle too short because you are loosing water. Water may be leaking thru the dump valve. Look at drain while machine is running and see of alot of water is draining. The dump valve spring may be week or there is trash in the dump valve preventing it from seating properly. drain water first before pulling dump valve apart.
2/11/2017 10:16:01 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
We have a failed condenser fan motor which was a
Motor usually trips out as it is overloaded. Check the rated amp draw on the replacement motor verses the OEM motor. OEM motors usually are built a little different to meet certain conditions in their design. You may need to get one. Also, make sure your condenser is very clean so as to not cause overloading the motor. Could have been the reason for the first one to fail.
2/11/2017 10:12:47 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
Beeping 3 times every few seconds
In the freeze cycle too long. Usually about an hour. Several conditions can cause this. look for stuck float or constant water running even when machine is off. start there first.
2/11/2017 10:03:35 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
Ice maker not making ice.
Do not use test button. It test the functions of the board only. You have another issue. Need to know the number of beeps. Usually beeps a certain number of times, then hesitates,then beeps again.
2/11/2017 10:02:06 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
I have a model #
Sounds like the water valve is stuck. Probably needs replacing. Turn off water after machine shuts down and see if water stops. If it does, water valve is most likely the issue.
2/11/2017 9:58:43 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
Water only runs in the
If you have the switch in the "Ice" position and the water pumps never comes on, but the pump runs in the "wash" position, it is most likely the switch itself. Seen this many times. Weird condition and most techs will replace the board first and not check the switch. Start there.
2/11/2017 9:57:38 PM •
Hoshizaki...
•
Answered
on Feb 11, 2017
Not finding what you are looking for?