20 Most Recent
True Refrigerated Sandwich Prep Table 72" 30 Pan - Page 8 Questions & Answers
Replacing wiper gasket?
Rick,
Do you have the cabinet serial # for this GDM-37? With both Model and serial we can locate the wiper gasket you need. From just my primary research this is a 52" wiper gasket. We work with True models a lot and are able to order OEM wipers directly from True at a price below the list. We'd be happy to help you.
Shoot us an email with model and serial and we'll quote you price and availability for the wiper gasket.
[email protected]
855-288-2259
Thanks,
Matt & The Cooler Gaskets staff
1/2/2014 9:32:41 PM •
True...
•
Answered
on Jan 02, 2014
Model GDM-69
A GDM 69 three doors. Each door closes using a string attached to a weight, which runs through pulleys or copper tubing, and is held to the top of door. The pulleys or copper tubing can be accessed by removing the aluminum siding located inside cabinet on either side. The left side contains the pulley and weightfs or left and center door, the right for right door (each held on by 4 1/4 screws) . To make the door close, simply make sure string is attached to weight, running though pulley, and attached to top of door.
11/27/2013 1:07:11 AM •
True...
•
Answered
on Nov 27, 2013
Flip doors on gdm-07
Only if there are screw holes on the opposite side. In that case, invert the door, install in other screw hole. Most likely, since true won't give up diagrams, you would have purchase a left hand door and hinges. Call true at +1 800 325 6152
10/29/2013 7:03:20 PM •
True...
•
Answered
on Oct 29, 2013
Refrigerator thermostat
Try a Supco 3n1 start kit. If that doesn't do it then the compressor is done. Call the man, or woman.
10/29/2013 6:47:53 PM •
True...
•
Answered
on Oct 29, 2013
Water leaking from the top
Assuming inside the cooler, your drain tube is clogged. Need to blow it out. Compressed air will do it. Drain empties out below next to the compressor. Unplug the unit first!
10/29/2013 4:28:14 PM •
True...
•
Answered
on Oct 29, 2013
Where is the thermostat for tpp-93?
Should be between the two evaporators, knob may have fallen off making it hard to recognize . It has a very short shaft with a tab close to it. If you have drawers you have to remove all drawers to reach it.
10/29/2013 3:59:53 PM •
True...
•
Answered
on Oct 29, 2013
TRUE REACH IN MN TSSU 60-16 LOW SIDE IN NEGATIVE
This is a cap tube system. Try replacing filter, they often become clogged due to the oil used in the system. Cap tube can be clogged as well. could simply be low freon level. Evacuate the system and weigh in R-134A, amount is listed on model sticker. Also remember that when you attach gauges to the high side you are removing up to 2 oz., or more from circulation. Use a gauge with a short hose, like 6", on the high side. Be sure to bleed your low side hose with 134a before attaching to prevent moisture entering system, that also turns the oil to acid and deteriates the filter and clogs cap tube.
10/29/2013 3:32:53 PM •
True...
•
Answered
on Oct 29, 2013
Not finding what you are looking for?