20 Most Recent
Ariston Technologies AW125NA 13 lbs. Load Capacity Washer - Page 6 Questions & Answers
I have a code H 20 then it goes to F01
The washing machine fails to load water (The wording H20 is
displayed).
• The water inlet hose is not connected to the tap.
• The hose is bent.
• The water tap is not turned on.
• There is a water shortage.
• The water pressure is insufficient.
• The START/RESET button has not been pressed.
F01: Triac Short circuit
Overhaul CNE
Replace Card
Dado
10/6/2015 6:36:48 PM •
Ariston...
•
Answered
on Oct 06, 2015
Ariston washer/dryer arwdf129na
F04: Overflow and Pressure Switch Empty found at the same time (Pressure Switch stuck on Empty)
Overhaul CN1
Overhaul Pressure Switch Contacts
Control CN1/Pressure Switch Continuity
Replace Pressure Switch
Replace Card
Dado
10/6/2015 6:33:12 PM •
Ariston...
•
Answered
on Oct 06, 2015
Why is h20 sign popping up
The washing machine fails to load water (The wording H20 is displayed).
- The water inlet hose is not connected to the tap.
- The hose is bent.
- The water tap is not turned on.
- There is a water shortage.
- The water pressure is insufficient.
- The START/RESET button has not been pressed.
Dado
10/6/2015 6:15:42 PM •
Ariston...
•
Answered
on Oct 06, 2015
Having a problem with our washing machine, it will not engage in teh apin cycle
F01 - Electronic circuit board fault
Issue: Washing machine is not operating - some or all functions are not selectable.
Cause: Main module, triac on board damaged or components feedback fault
Advice: We recommend you disconnect (unplug) the appliance from the mains supply for a minimum of 2 minutes. Reconnect supply and wait 30 seconds and try starting the machine again.
Dado
10/5/2015 7:59:16 PM •
Ariston...
•
Answered
on Oct 05, 2015
Ariston ARF 105 H2O error!
I had this issue also and it was because I started the machine and had not turned on the water to it. However, it cleared when I unplugged the power cord, waited about ten seconds, then plugged it back in. I guess they need a "reboot" once in awhile, like a computer - at least mine did. Hope this works for you, too.
9/5/2015 11:53:18 PM •
Ariston...
•
Answered
on Sep 05, 2015
Aquatis AQXXF 129 h. what is the error code 08?
It means "heater relay cannot be activated". Troubleshooting guide says to tap the relays to try to unjam them. If that fails, replacement of the main control board is necessary. These washers apparently have a propensity for stuck relays on the newer units.
8/17/2015 4:40:56 AM •
Ariston...
•
Answered
on Aug 17, 2015
INDICATING h2O CONTINEOUSLY draining water
h2o is the chemical symbol for water. But if the water keeps running and does not stop, even when the machine is full it could be the machine has a defect level indicator, or the water lock does not work. When the lock even don't closes what you remove the power the lock is defect.
3/24/2015 11:32:45 AM •
Ariston...
•
Answered
on Mar 24, 2015
Not finding what you are looking for?