20 Most Recent
Bunn 10 Cup Home Coffee Brewer - Page 9 Questions & Answers
When we make a pot of coffee, the water goes
This is usually caused by a missing sprayhead above your filter basket. take out the filter basket, and see if there is a sprayhead up there, or if there is just a little round pipe that the prayhead screws on to. If it is missing, you can contact your local Bunn dealer, or phone bunn directly, and they will take care of you. You can get a list of repair centers in your area at www.bunn.com
Over running, doesnt drain thru filter as fast as
Sometimes this happens if you use filters that are too thick for the brewer. If you are using Bunn filters andthis keeps happening , up above your filter basket, there is a sprayhead. Turn that off, and look at it to see if it is plugged up.If there is no sprayhead, then that could cause your filter basket to overflow, as too much water will be coming into the basket too fast.
Bunn keeps blowing the circuit when pulled in
If the circuit resets with the coffee maker unplugged, the coffee maker is at fault. There is a defective part in the unit that is shorted causing an overload in the circuit. You will have to isolate the bad circuit and replace or replace the coffee maker.
My 10 cup Bunn coffee maker leaks from the top
I have the same problem and I took the coffee maker apart to find out why. It has to do with a leak on a fitting. On mine I found that the fitting where the hole in the black plastic that the water flows through to get into the stainless steel tank needed to be repaired with some silicone sealant to fix the leak. Still making some coffee!
My bunn GRXB leaks from the bottom when i add
Hi.
This needs surgery - so make sure it's unplugged, then remove the base & covers.
Look for leaks around seals and pipes.
80% of the time - it's a seal that is faulty. You can contact the manufacturer for a replacement - or - just use standard silicone sealant to apply a thin layer over the defective area of seal - then re-assemble.
Silicone is so effective thesedays - that engine sumps are "glued on" rather than using a solid gasket. I'ts cheap and effective for repairs like this also.
Water coming out from underneath bottom of unit
If this is one of those units with the leaver that starts brewing when you close the fill lid, I have the fix.
What has happened is that the "tank" that holds the just added water has deteriated due to heat from the stailess steel tank that hold the hot brewing water. This tank remains hot as long as the side switch is in the "on" position.
You will have to remove the (3) screws that you can see from the top of the coffee maker. (2) are under the lid where you fill water. Remove the top of unit. You will find the lever in this "tank". You will need to remove the lever to access the fitting that screw into the stainless steel tank. This is the area that has deteriated from the heat. You will also need to remove (2) screws to be able to remove this "tank" for repair.
After you clean the area where the "fitting" was removers from the top of the stailess steel tank. Apply a bead of RTV silicone around this area. This can be found in automotive stores. The RTV will form a seal around this deteriated area.
IMPORTANT Make sure you don;t put to much RTV on parts. You don;t want to interfere with the seal on the leaver. Replace the "tank" along with the washer & fitting. Replace the (2) screws also. Replace the leaver. Replace the top cover with the (3) screws.
Let unit sit overnight to allow RTV to set.
I have done this fix twice. 3 years apart.
I have not been able to find this part to purchase sepratlly.
I can't see paying $85 for a refurbished unit.
Brewed coffee mess
You may be grinding the coffee to fine making the draining a little slower. There's something called a fast flow filter that may help also. Also, make sure that you aren't jamming the filter down to partially block the drain hole ensuring that it is freely draining out unobstructed
Our coffee is weaker and bland the past few days,
If this is a BUNN, the problem is the heating element is turned of by the switch on the side or the heating element is bad.
Feel the rear tank area of your unit. it should feel warm to the touch at all times that is is plugged in. The water must be up to temp to work properly.
HAVE LOST MANUAL. HOW DO I CLEAN IT
You will need the de-liming tool to proceed. Run a pot of white distilled viniger thouth the coffe maker. Viniger is a excellent cleaner & will not hurt any internal parts.
Water leaks out from underneath coffee maker
Well they don;t give these away for sure. Lets see if we can help you out. ? are you over filling it.This happened to me because I was reading the fill line wrong. {got new glasses} . If not may be you could try makeing less. But if only 1/2 cup comes out and no more, that wouldent indacate a leak in the tank, if there was it would all leak. Try backing off on the coffie and water, and see if it still leaks. if it does get back to me. DFD
Restart a bunn coffee pot after it being off for 6 months.
Hello. Hope this is what your looking for:
http://www.bunnomatic.com/pdfs/commercial/manuals/33545.0000.pdf
follow the instructions for first setting up the unit, as most, if not all the water has evaporated by now. Don't plug it in yet :)
if not you can go to www.bunnomatic.com and download the appropriate manual, there is a link on the left side of the page, click and choose your unit.
Hope that helps, and thank you.
Bunn 10 cup coffee maker leaks around the top of the tank
Hello. I would say that you are going to have to call: For repair information, call 800-352-286. They don't usually supply commercial repair houses with part information, or you could try here:
http://www.bunnomatic.com/retail/service/service_form.html
They will be able to get you what you need with minimal effort.
Hope this helped, and thank you.
Not finding what you are looking for?