20 Most Recent
Brother SE-270D Computerized Sewing Machine - Page 6 Questions & Answers
Error Message This embroidery card cannot be used with this machine
Is it a pre-loaded card - or one you add patterns to?If its one you add patterns to, make sure the pattern isn't too large for the machine. EG if machine does 4"x4" and you've loaded a 5"x7" pattern, try down-sizing the pattern/ breaking it up into smaller sections to load & sew
Sewing machine
rethread the machine & see if the thread is caught anywhereif that doen't help turn the machine off for a few seconds & the turn it back on to see if that will clear it.
I have a Brother BC2100
I might have the same problem and I think is due to the fact that the needle is too close to the foot so the adjusting of the tension does no influence.
Downloads to iMac
Google "BriTon Leap" for solutions for using your iMac. They have programs called Embrilliance, which works with iMac
When i sew shirt sleeves on there always tight in
is this a fitting problem with the pattern? or do you mean that the seam is pulling up?If the sleeve pattern is too small, then you may need to alter it.There are lots of books on altering to fit you, Palmer Pletch write several and you should be able to find these in the library. But put simply, you need to add some more fabric in to the back of the sleeve if its too tight in the top of the shoulder and the easiest way is usually to "slash and spread " the pattern piece, then paste this new shape down over a sheet of paper and remark the outside cutting edge. Remember, if you add in an inch in the back of the sleeve piece, you will need to add an equal or similar amount into the back of the shoulder where the sleeve fits in to match.
Bottom thread is looping.
If the thread is looping on the bottom, then your problem is on the top. Pull the thread out of the needle and and put the presser foot down. If the thread pulls thru easily, then you need to rethread your machine making sure the thread is thru the top tension wheel correctly.
Rule of thumb::
Loops on the bottom, Problem on the top
Loops on the top, problem on the bottom.
Problem with my machine
l have a pe-200 brother machine and the needle won't go down and is making a noise can anyone help .l have checked belt and that's fine thanks
Not finding what you are looking for?