20 Most Recent
ViewSonic VA721 17" LCD Monitor - Page 3 Questions & Answers
Screen no signal
Your power cable from monitor to CPU is not connected properly.
If it not works after checking.
Then change power cable and it will work.
Since a couple of days fussi leters
change the resolution until get one that shows them ok ...this can be changed from the image driver (the driver for the video-card) or from the right click on the desktop...properties...settings..
How to disassemble
There is ccfl(cold cathode fluroscent lamp) tube which is faulty therefore no light is there the ccfl tube operates on 600vac with 40khz-60khz so check 600vac to the tube if no voltage is there then check circuit and to open see any locks available there if no screw is observed take a smallest screwdriver (preset alligner)to open the lock
I cant figure out how to fix the resolution on my
When you power up the computer press F8 key then enter in "Enable vga mode" then go to start menu->control panel->display property->settings .
Change screen resolution to 1024*768 then apply and ok.
Let me know if you need further assistance.
Thanks for using FixYa.
No signal anolg
good day,
maybe there's a problem with your VGA or the cable wire that connects the monitor and VGA....try to approach technician near to you.....
best regards,
kaybicks
Nais ko po munang batiin ang inyong show na
Pwede mo sya idemanda lalo na't kung kayo ay kasal. Responsibilidad ng isang ama ang suportahan ang kanyang mga anak.
Ang pinaka magandang gawin mo ay pumunta ka sa pinaka munisipyo o City
Hall ng inyong bayan at hanapin mo ang PAO (Public Attorney's Office).
Ang PAO ay nagbibigay ng libreng serbisyo sa mga nangangailangan.
Maraming Salamat!
A pop up window appears and says no signal analog
this is most likely a pc hardware issue and not a problem with the monitor itself.
1. check cables and power switches.
2. remove devices from power strip and then plug them back in one by one.
3. try alternating memory sticks to diagnose if one may be bad.
4. remove pci dial up modem card.
5. if you have an agb, pci, or pci-e video card remove it and plug monitor onto the onboard video if the option is present. if not test with a known good video card.
6. if possible test pc power supply with known good power supply as it may have gone bad.
any damaged piece of hardware could potentially cause a system to not post or display to a monitor check these first as they may be the most likely culprits.
hope this is helpful.
I need a driver
ViewSonic VA721 VA721 Monitor Driver ... Login. Register ... Uninstall Windows drivers How to Uninstall Windows Drivers and why you need to know it ...www.nodevice.com/driver/VX500/get36507.html
Contrast menu keeps popping up in my moniter,it is
mmm look you have a setting problem reset the screen to it's defulat if it didn't solve the problem you will have to change the press bottoms and you will need some who know electronics to help you with the board but first try to rest it to the defulat settings
Ibm 9513-ag1 flat monitor broken switch
I have the same monitor. I had the same problem you have. I couldn't find the correct replacement part so I improvised. The plastic part you refered to just activates a micro switch on the circuit board. In my case the micro switch worked just fine so I used 5 plastic buttons off of some ball point pens as a replacement. I took the monitor out of its plastic case and drilled holes in the front bezel directly over each of the 5 micro switches. I then put the buttons from the ball point pens in holes. So now the push buttons from the ball point pens act as a substitute for the broken part. I hope this helps.
Not finding what you are looking for?