20 Most Recent Mag Innovision LT982s 19" Flat Panel LCD Monitor Questions & Answers

check your cable to speaker of your monitor and to the audio output of your pc.

yes the power supply or capacitors are shot. the part u want is from proview technology inc
attn: parts dept.
7373 hunt ave
garden grove,CA 92841

it is the lcd power supply, P/N 860-ALZ-M713W-f
F0742683G
1-800-776-8439 follow prompts....ed

ebay sometimes have repacement parts or one that is good for parts

The power lead you need for this monitor is a standard EU 3 pin. you can purchase these from any good electrical or computer store.

The look like the old Kettle plugs if its of any help

You more likely to thave power supply problem.

Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply, blown fuses, poor solder joints, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/home/budm/allalbums
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://en.wikipedia.org/wiki/Capacitor_plague
http://www.badcaps.net

When the LCD Controller cable is diconnected from the LCD panel, the screen should be completely white due to the Liquid crystals do not have the bias voltage to block the backlight from coming through the front of the screen. Unless you have intermittent shorts circuits on the LCD controller board (part of the LCD panel) that load down the 5vdc (logic power supply). The capacitors on all the board look OK? See the pictures of bad caps in the monitors here and post back what you see on your boards so we can go further with troubleshooting.
http://s807.photobucket.com/home/budm/allalbums
http://en.wikipedia.org/wiki/Capacitor_plague
http://www.badcaps.net

oky just gett a new t.v..

Is there a separate ON/OFF "rocker" switch, in addition to the ON/OFF button on the front of the unit?

Have you tried a different power-cable?

If all else fails, take the monitor to a qualified technician, for more trouble-shooting.

Hello,

The white screen is caused by the power supply board not providing the correct voltages to the display driver board. Check our web site at: www.ccl-la.com We have repair guides for many LCD monitors and there is a guide that will work for your LT982 monitor. If you don't want to do the repair we do offer a repair service for $35 plus return shipping.

I hope this helps, If so please rate our solution.

Buddy
Corporate Computer
www.ccl-la.com
[email protected]

I solved the problem myself by going to the homepage of MAG Innovision and i downloaded the manual i needed from there...Thank you.

You can pick one up at Walmart. Standard computer/monitor cord.

Go to control panel and find volume sound and put the WAVE up on line.
Vitally

lol that old thang u have to but a whole different pice just buy a new one lol ty

Beautiful screen, lasts about for a few minutes, goes black. Power button still green. If I turn it off, and then back on, it works again for a while. Any ideas?

Shut the computer off, hold the power button for five seconds.

Once it's off, turn it back on and tap the F8 button until you see a black and white safe mode menu. Use your arrow key to select Last Known Good Configuration and then press enter.

This should get you back to your previous settings.

If it doesn't work simply comment back here and let me know how far you got.


Chris

Hi,

Often the plug of the power cord and its mate, the jack in the monitor, would have to conform with the region/country of its intended use. Having said this, then it is possible that your particular version is meant for another country but is likewise sold in your country. A picture of the monitor's connector would help narrowing the selection and possible source/supplier. Pls post if able.

Alternately, you could try viewing the different types here, here or here to get the specific part number or model of the AC cord.

Incidentally, most electronics shops/stores sell a variety of power cords, perhaps a visual check would further assist you.

Hope this be of initial help/idea. Pls post back as requested, how things turned up or should you need additional information.

Good luck and kind regards. Thank you for using FixYa.