LG Studioworks 700S 17" CRT Monitor - Answered Questions & Fixed issues

Remove any speakers or magnets that you might have near the monitor as they can cause visual distortion on your monitor screen.

look listen and dance not matter how you performance keep it calp and trust it

it can be a broken monitor or a faulty video card. try replacing your video card. hope this helps

Hi,Sir/ i have lcd monitor Hp-L1502 its on position wen i start lcd without vga cable to frount lokation is red+green+blue colours step by step fliker&i can fix new vga cable.whats sulution?

LG 700E monitor's power LED blinking continueously, no displaySolution.............

Most problems in the crt monitor are caused by a bad flyback transformer. It is far cheaper to replace the monitor with a new one.

THE PRESCRIBED ARROWS ARE FUNCTIONING WELL FOR INCREASING THE VERTICAL SIGE OF THE DISPLAY OF THE MONITOR.BUT THE HORIZONTAL AROWS WHEN OPERATED ARE NOT ABLE TO INCREASE THE HORIZONTAL DISPLAY OF THE MONITOR TO FULL SIGE. PLEASE GIVE APPROPRIATE SOLUTION.
THANKS

http://www.shvoong.com/how-to/computers-and-internet/2029464-lg-700e-crt-monitor-settings/

BEST ANSWER :- GO TO THIS LINK :-http://www.flickr.com/photos/chimanya/4835019254/ YOU CAN SEE STANDARD SHAPE SETTING FOR LG 700E MONITOR

BEST ANSWER GO TO THIS LINK :- http://www.flickr.com/photos/chimanya/4834437197/in/photostream/you can get standard shape setting for LG 700E monitor

lg monitor sound ngeret,, ga power lights the flame ...... y KNP .... Boss??? please solution

Unlock the base first. Keep the monitor upside down on a soft flannel or any thing like that. there is tow clip locks on the top portion of the cabinet. Unlock it very carefully, after unscrew out the two screws at its botton side. Pull the back cover causiously.

HelloCheck the DC voltage in to LOT. If not power supply section should be troubleshooted. If there is voltage and still no EHT, LOT should be suspected.

Suspect the LOT

HelloThe problem is with some loose solder points inside the circuit board of the set. Just resolder all the suspected solder points by applying a little more solder, without making any solder bridge short in between adjecent solder points. Note the solder points of components, that will heat up while working. Resolder these solder points as I stated earlier.

HelloThe display processor IC [ on the neck card ] has damaged. Replace it with same number.

HelloSelect reset option by monitor menu, set it to default first. Then try to adjust the width and height of the screen. If this does not help you, try other resolutions set by the system.

HelloIf the monitor displays these vertical bars, after a service has been done to it, and if LOT has replaced, there is a mismatching problem with replaced LOT and the defelction yoke.

There is some short circuit on the circuit baord. Check it. Horizontal output transistor and LOT should be suspected.

A width issue specially if this is short of width on the screen can be due to many reasons:1. It can be a low +B which means the SMPS power supply has a lower output due to low Switching or a low value on the main capacitor. Check this out, measure the +B on the mains end and also the secondary side which will confirm.2. If the secondary +B is correct the fault can be with the sync circuit IC or the horizontal coil or even a fault with the deflection coil. A proper measurement of the voltage in this section is important.3. Check for weak capacitors and DRY soldering on the horizontal section , line output section.