20 Most Recent
LG Studioworks 700S 17" CRT Monitor - Page 9 Questions & Answers
I need to get monitor
Just click on any empty space on start up tool bar and drag to buttom of ur screen...
Fluctuating display when processing data in my PC
Hi,
Does it mean that text, or any data found in your monitor has a shadow? There is nothing wrong which kind of system your using (xp, linux) it is on the monitor. It is on the mixing of color, the repair man/technician knows how to adjust those things.
Thanks
Dark colors
Increege LOT screen preset
check G2 voltage at neck board G2 cathode
remove Sg caps
replace G2 pf
LG 700E COLOUR CHANGES
you have touch up the solder point at the pict board. Because the solder joints dried up - lead poor contact.
Display monitor
dear sir
bind is connected to east west ,,if you cannot control it contro pannel you have to change 630 trasistor,, it may have a leke or solder lose
Dark display
dear mr faolib
the solution is to install a 250 ohm resistor between G1 and ground on the socket ,,,but you may change it more or less than 250 ohm . it well be lighter and you you can adjusted normally from controll panel
ghassan eid
00962776936354
[email protected]
No dispaly on monitor
i have purchased a sigmatel s90 dual sim phone but by mistake i entered flight mode. Please send me details in english to get back to the normal mode and if possible could you send me the details in english. Thankyou i would be grateful
MOBIN_KHORSHIDEE
Samsung Monitor Model: Syncmaster 753S (ANNN17LS7L/EDC Chassis)
No power
I discovered IC601 (DP704C) had exploded, Equivalent for this IC is 6S0765RC
(Anonymous)
http://www.e-repair.co.uk/tipsmon.htm
Wiring problem
waste of time.
if you need a monitor, buy a monitor.
if you need a tv, buy a tv.
How can i open mylg e700.
I have repaired various LG monitor & they all seem to suffer the same problem with the led flashing. The fault is fixed by replacing Q719 which is a Mosfet IRFS640 & C744 100uf100v cap, also check caps in power supply a couple of 220uf63v pop from the bottom. I have had the line output transistor s/c.If its the one Im thinking of, to take the back off . Tip the screen on its face & with a pair of long nose pliers wedge them into the clip at the bottom & use a flat blade screwdriver to prise the bottom slightly away. Then place the monitor upright using your screwdriver you have to pop the top. Push 2 inches from each corner. You have to push hard. Good luck.
Not finding what you are looking for?