Magic Chef CYE2000 Electric Commercial Dryer - Answered Questions & Fixed issues


https://www.repairclinic.com/Shop-For-Parts/a8b104d87061/Model-CYE2000AYW-Magic-Chef-Dryer-Parts

The dryer requires cycling of the heat to advance thhe timer on auto dry cycle. see ,link provided parts and repair guidance. Always remove from power supply first.

I’m happy to assist further over the phone at https://www.6ya.com/expert/david_dc2f9e0a44104720

Magic Chef... | Answered on Oct 01, 2017 | 79 views


The fuse is located to the right of the element


9_5_2012_2_23_08_pm.jpg

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Magic Chef... | Answered on Sep 05, 2012 | 54 views


If you are having dryer problems and you cannot even get the thing to start, then you might want to start going through this check list of possibilities. There are a number of things that can cause your dryer to not run.

A couple of the most common problems are the thermal fuse has blown or the door switch is not operating properly. On many dryers if the thermal fuse blows, the dryer will not run at all. This fuse can be checked with an ohm meter. It should show continuity if it is okay. If there is no continuity then you need to replace it and also find out what else failed. This is a safety device that usually blows because something else allowed the dryer to get too hot. It is usually located in the back of the dryer, on the blower housing. Some are oval in shape and others are rectangular, usually with two wires attached.

A defective door switch or a bent door switch lever can also cause you to have problems. If the lever is broken or bent it will not activate the switch. If the switch is broken, this also will not allow the dryer to be started.

The push (or turn) to start switch can go bad, but is unlikely. To check this, hold it in or turn it and then check to make sure you have continuity with an ohm meter.

If the dryer starts and then stops when the switch is released check the control board or the ?even heat? control on some model dryers. Some dryers have a belt break switch that can fail or your belt may be way loose or broken.

Check for burn marks or burnt wires at the terminal block on your dryer, poor connections can cause all kinds of problems. Also poor connections can cause fires.

A bad power cord also falls into this same category.

Of course, always check that you have the proper voltage to the outlet that you are plugging into.

http://www.fixya.com/support/r4312805-dryer_maintenance

http://www.fixya.com/support/r3866744-dryer_not_working_dryer_not_drying

http://www.fixya.com/support/r3907570-buy_appliance_parts_online

http://www.fixya.com/support/r3866345-dryer_troubleshooting_electric_dryer_won

http://www.fixya.com/support/r4496386-dryer_cord_wiring_dryer_3_wire_or_4_wire

http://www.fixya.com/support/r4416566-dryer_repair_squeaks_grinding_clicking

http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning

http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start

http://www.fixya.com/support/r4398592-gas_dryer_not_working_gas_dryer_not

Magic Chef... | Answered on Jun 06, 2011 | 86 views


check these:

http://www.partselect.com/dryer+dryer-wont-start+repair.htm

Magic Chef... | Answered on Jan 11, 2011 | 103 views


Get the drum out and clean up the area inside the dryer. Check the blower wheel is tight on the motor shaft. Oil the rollers and idler with zoomspout oil. Place the new belt onto the drum at the mark where the old one ran along and use the belt to set the drum back over into the dryer. Remove that brace number 24 so that you can get your arm in there. It is better if you have the dryer on a tailgate or appliance platform. Reach in there with your left hand and loop the belt onto the motor as you raise up on the idler. Release the idler to where its spring action will hold the belt to the motor and drum.Then slowly turn the dryer to make sure the belt is in the mark on the drum and is not twisted.

I have some Maytag type dryer service manuals HERE

Dryer belt routing information is HERE

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Magic Chef... | Answered on Dec 02, 2010 | 190 views


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor going bad...

Here are a couple of tips that I wrote will help you to figure out why your dryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101
,.,

Magic Chef... | Answered on Nov 23, 2010 | 61 views


Hi,

There can be many reasons why your dryer will not start or turn...

The most common causes are the belt breaking or jumping off, or the motor goingbad...

Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...

Dryer Repair - The Dryer is not Turning

Dryer Repair - The dryer will not start


heatman101

Magic Chef... | Answered on Oct 28, 2010 | 73 views


The belt is likely broken. To be sure turn the dryer on and listen if you here the motor running the belt need to be replaced http://appliancehelponline.com/dryerbeltvideo.html If the motor is not running it could be a few other things and this link should help
http://appliancehelponline.com/edryerheatsnospin.html

Magic Chef... | Answered on Jul 13, 2010 | 157 views


Most likely culprit is the thermal cutoff located on the right side of the heating element housing (behind the dryer drum under the top) La-1053 is the part number for these I believe.
Good luck!!

Magic Chef... | Answered on Jun 16, 2010 | 162 views


thermal fuse near heater tripped. replace the thermal fuse and high limit t'stat. then check for airflow restrictions, ie;plugged vent, buildup of lint in front of dryer wher ethe screen goes down in. if you don't make sure airflow id sufficient it will blow the thermal fuse again.

Magic Chef... | Answered on Jun 15, 2010 | 119 views


The easiest way is to remove the front. You can then see between the inner and outer drum without removing the rear bearings and heat elements.

Magic Chef... | Answered on Jun 07, 2010 | 169 views


Hi,
If you have a gas dryer2_bing.gif.
The most common problem with a gas and no heat is the ignitor going bad...

Here is a tip that I wrote about that problem...
Gas Dryer2_bing.gif not Working Gas Dryer2_bing.gif Not Heating
http://www.fixya.com/support/r4398592-gas_dryer_not_working_gas_dryer_not

If your dryer is electric2_bing.gif..
There could be a number of different problems...
Check out this tip that I wrote about this problem...

Dryer Troubleshooting2_bing.gif Electric2_bing.gif Dryer won t Heat
http://www.fixya.com/support/r3866345-dryer_troubleshooting_electric_dryer_won

heatman101

Magic Chef... | Answered on May 06, 2010 | 67 views


check your hi-limit and cycling thermostats located on the element case the one will have a red and yellow wire to it and the other will have 2 red wires to it and they will be connected in series as one of the red wires will be in between both thermostats

Magic Chef... | Answered on Apr 15, 2010 | 112 views


There is a thermal fuse inside the dryer usually located behind the back cover on the upper part of the combustion chamber. When this fuse "blows" it turns off power to the whole dryer. This keeps your house from burning to the grown, and you from dying. The fuse "blows" for a reason, most likely to is lint build-up in the dryer and/or dryer vent system. The good new it only cost a few dollars to get a new one. The bad news is you need to find out why it "blew", the dryer got to hot for a reason.

Magic Chef... | Answered on Mar 04, 2010 | 526 views


Sounds like your problem may be with the heating coil.
If you plan to try to repair the problem yourself, then the first thing you want to do is unplug the dryer from the electric.
Remove the back of the machine and try to locate the air duct going from the blower to the drum. Normally inside the air duct you will find the heating coil and the thermostats/thermistor.
Once you have located the heating coil, remove the two wires from it and check the coil with an ohm meter across the two terminals of the coil.
You should read continuity across the terminals, if not you will need to replace the coil as it is faulty.
If the heating coil is ok, then:
You can check the thermostat/thermistor by removing the two wires and taping them together with electrical tape.
If the coil heats up then replace the thermostat/thermistor.
DO NOT LEAVE THE WIRES TAPED TOGETHER AFTER THE TEST. This could cause a fire, as you have removed the saftey of overheat from the machine.
I will include these two websites for parts and further help:
http://www.partselect.com/
http://www.appliancepartspros.com/index.aspx
Both also have chat assistance 24/7.
Good Luck,
Hope this helps

Magic Chef... | Answered on Oct 19, 2009 | 160 views


remove the vent from the back of the machine, run it full of clothes from the washing machine and if it dries nicely, then you have a clogged vent that needs replacing.

Magic Chef... | Answered on Jun 16, 2009 | 262 views


You probably have a broken drum drive belt. Your local appliance parts store will have them.

It's an easy part to replace.

Magic Chef... | Answered on Jun 13, 2009 | 84 views


This web side will help you to learn about your dryer

http://www.partselect.com/MultiModels.aspx?ModelNum=CYE2000&searchTerm=img_52479&RefineSearch=0&imgMfg=Maytag

I hope this will help you'

"Did it solve your problem?"

Magic Chef... | Answered on May 09, 2009 | 195 views


first check the vent to see if its clogged with lint.

Magic Chef... | Answered on Mar 30, 2009 | 121 views


replace the fuses and your problem is solved........

Magic Chef... | Answered on Mar 14, 2009 | 147 views

Not finding what you are looking for?
Magic Chef CYE2000 Electric Commercial Dryer Logo

33 questions posted

Ask a Question

Usually answered in minutes!

Top Magic Chef Dryers Experts

Gene Pitts

Level 2 Expert

159 Answers

jimorris77

Level 3 Expert

411 Answers

Nathan Van Boven
Nathan Van Boven

Level 2 Expert

206 Answers

Are you a Magic Chef Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...