Magic Chef 31100 Gas Kitchen Range - Answered Questions & Fixed issues
Magic Chef super capacity range.
oven takes to long to heat, broiler works fine, even the clock works it's just not heating fast....the bottom lights up,but not the top?
Broilerdoes not come on
Hi,
This is usually caused by a weak igniter. If the igniter is weak it will not allow the safety valve to respond correctly. I recommend replacing the igniter.
Hope this helps.
Shane
My Magic Chef model 9112XUB
If this model has electronic ignition, you can open up the broiler door , turn on the oven, and look to the rear of the broiler...there should be a sort of glow plug getting reddish/orange. If not, the oven won't light and you will need to obtain an ignitor for the oven. these are available through appliance parts distributors such as Bell Parts Suppy. If it is a standing pilot model, then first check to see if the pilot is lit...if it's not lit try lighting...if it won't stay lit, then the thermocouple is probably bad and will need to be replaced
Oven temp drops to low before burn turns back on
You have a bad oven temperature sensor. It is in the back top of inside of the oven. It changes out pretty easily two screws and pull it out until the plug is visable, unplug the old and replace, push wires into back.
insert scews. Good luck!
Oven does not get hot F1 F7 error message. one burner does not
Hi there
Heres the codesfor you and hope this helps and let me know.
F1
Defective touch pad or clock (ERC)
Replace touch pad or clock (ERC). Touch pad is a more common problem.
Refer to F1 test at the top of this page for more information.
F7
Function key shorted or stuck
Replace touch pad or if touch pad is part of the clock, replace the clock
(ERC).
Thank you for writing to fix ya.
Best regards Richard
Annoying beep
On models where the keypad and electronic control are one integral part
which can not be separated, an F1 error can be caused by a problem
in the oven temperature sensor or its wiring circuit. If not it's the keypad.
Oven, Broiler will not ingnite
ok try this turn the bottom oven on count to thirty then smack the safty valve with the plastic end of a screwdriver its the square box with two wires on it that the burner tube goes to underneath if it lights replace it
Magic chef oven
change the bottom ignighter just because it glowes doesn't mean its getting hot enough to open the safety valve you should see two screws at the bottom of the floor of the oven cavity after removing the racks remove those and remove the floor then you will see a deflector shield remove that to get access to the ignighter take out the two screws and install the new ignightor and reassemble
Not finding what you are looking for?