20 Most Recent Magic Chef 9512 Electric Single Oven - Page 3 Questions & Answers

Did you end up finding the manual?

See the installation instructions, page 9. https://mcappliance.com/media/manuals/MCSWOE24S.pdf

Try this site https://searchmanuals.net/search7/?keyword=%2Bowners+%2Bmanuals&gclid=CjwKCAiAqt7jBRAcEiwAof2uKwzE1jBmBNKl9hqWd4TyeToXsj80tGOrdxRc3s6LGEWtoEA-xsOXLBoCIhQQAvD_BwE

Check each wire going to the igniter for opens. Test both ends for continuity.

I would suggest the control switch is defective.

Possible locations shown in article at the web link below: https://www.hunker.com/13409112/how-to-find-a-model-number-on-a-magic-chef-oven How to Find Model Number on Magic Chef Oven Hunker Quoting the link above: Step 1 Open the oven door. At the top, left-hand corner of the open oven, locate the model number tag. Step 2 Check under the burners. Lift each burner on the stove off to see if the plate is underneath. Do this if the plate is not located on the inside of the oven.

hope this helps a little... https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Range-Stove-Oven/15-104--/Magic-Chef-Stove-burner-won-t-light

here you go... has to be item 3. hope this helps and you have a good day. go here..... https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Range-Stove-Oven/16-104-82185-/new/Magic-Chef-Oven-temperature-not-accurate-59F5TXW

There is a fuse. It is on the noise filter under the outside cabinet. You would have to remove it, however, with that being said. Do not touch the capacitor if you remove the cabinet as it can kill you if you do not know what you are doing. Make sure you unplug it from its power source and wait 10 minutes or more before entering the interior. You can buy just a fuse , it is a ceramic 250 volt 20 amp fuse. Magic chef wants you to buy the noise filter with the fuse on it, part number 3518608000. Please be so careful about this, it is no joke the capacitor can kill you. Good luck and again be careful.

Go to the Magic Chef website, enter your toaster info and user manual into the support section.

What is the model number?

need to leak test ALL lines and connections --most lp companies have a service person/company to do this they have the proper equipment to test and repair if needed