20 Most Recent Magic Chef 9512 Electric Single Oven - Page 2 Questions & Answers

Hi, If the oven is still locked the problem will be the latch you will need to replace it. If the oven is not locked then the igniter was damaged during the clean and you should replace the igniter.If you have any further questions please feel free to comment. Mike

push in on the themostat when the oven is on piolt hold a lighter under the burner and presto also light the stove to get gas flowing first this can take up to fifteen min to light if it has been awile since lit

Usually L1 is a code for power on. So try to clear it by pushing enter or clear and see if it helps.

Please rate me accordingly if this helps and good luck.

If the ignitor fails to pull at least 3.5 amps then it is bad. Go get another ignitor. That one is defective. If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Hi - Please post the model number of you appliance, it will look something like CEC1536.

Thanks.

hi. Thanks for the question. The problem is with the igniter . Replace it it is located under the floor of the oven .thanks the appliance doc

you can check you connections to see if loose wire nut.normaly people will say they hit the oven safty valve and gas will come out.the amp draw on that ignitor is as ive been taught 3.2 to 3.5 if low than that it will have a hard time opening the safty valve.ive sold and installed 100s of ignitors and a few valves.hope that helps.god bless tom

Replace the touchpad

YOU HAVE A BAD ELECTRONIC RANGE CONTROL OR ERC If you need further help, reach me via phone at https://www.6ya.com/expert/marlon_56d9a24f02585258

sam problem here

replace oven selector switch.

thats an electronic oven control any appliance repair store can get you one if not try here http://www.repairclinic.com/SmartSearch/smartsearch.aspx

Yes this is normal. you can use that burner to keep things warm without turning it on, saves energy.

I can't help much... When a gas burner sounds like a jet engine the chances are the gas is burning inside the mixing chamber. The gas jet directs the gas into a mixing chamber where it is mixed with the correct quantity of air before being emitted from the burner where it produces those nice blue flames. Sometimes, for a reason I don't know, ignition will cause the flame front to pass through the holes in the burner into the mixing chamber and the jet engine sound is heard. There will still be some flames from the burner but they will be weak and anaemic. The problem used to be very common in the days of coal gas but it has almost disappeared with the use of methane. I suggest you remove the burner and ensure it is clean inside and out and is a good and close fit against the gas jet and there is nothing restricting the air inlet of the mixing chamber.

Try the RV Forums. https://www.google.com/search?q=Manual+for+1984+Taurus+trailer ..

A blacksmith may be able to make the parts for you. Being over 70 years old, I doubt there will be any spares left.

Whatever is says on the temperature dial, usually about 500'F max https://www.google.com/search?q=how+hot+does+a+magic+chef+rotisserie+oven+get ..

do an online search their are hundreds of appliance part companies and sites that sell parts at discounted prices

and of course you have no manual either , neither do we