20 Most Recent HP Business InkJet 2800 Printer - Page 2 Questions & Answers

0helpful
2answers

Printerhead need replacing

Printheads are very sensitive and HP sets a "Time" limit of about two years for # 11 printheads regardless of how much you print. ( This is bunk from HP of course!.) But the prinheads do not expire!! They just show their health and that the printhead has exceeded the warraty period ( regardless of how much you print) .

Remove the printheads from their socket and fill a 8- 12" dish with 1/4" high of warm water. Set the printheads in the water in the same position they are set in the printer (vertical) You may need to place a wooden spoon of a block behind the printheads to keep the heads in position, as they will tilt backwards.
Leave the printheads to soak for about 15minutes.
Remove the printheads and slightly press them on a folded kitchen paper towel .It should show two lines of the same color of the printhead (cyan, yellow, etc) If the two lines are not of the same length (about 1/2" long) then repeat the soaking for that color. Be sure to dry the printheads properly

Install the printheads in the printer socket vertically so the contacts are properly set.. If not you may get a message to "Install (color) printhead". reset it again and run at least 15 pages with color information. It should print ok!!
If any print heads is damaged then the only option is to replace it with a new one.
It may be that the ink line from the cartridge to the printhead is clogged and ink is not flowing. This may require to run a large print job of about 50 or so pages to force ink into the clean printheads.

The terminal strip behind the printhead that makes contact with the pins in the printer are very delicate and if removed two to three times may not make a good contact and render the printhead unuseable.

Good Luck!!

JoeA
2/10/2014 2:59:58 PM • HP Business... • Answered on Feb 10, 2014
0answers

Pmr2006a.exe

Be the first to answer 1/2/2014 7:50:22 AM • HP Business... • Posted on Jan 02, 2014Be the first to answer
0helpful
1answer

Printer connected to power supply is not starting,

check the powercode/powerdadapter if its defective if not the printer powersupply is blownup you need to replace
12/5/2013 4:11:44 PM • HP Business... • Answered on Dec 05, 2013
0helpful
1answer

The printer repeatedly displays to remove the rear

Maybe a piece of paper is covering a sensor and that is why you are getting the error message.
12/1/2013 1:21:58 AM • HP Business... • Answered on Dec 01, 2013
0helpful
1answer

Feeds a blank sheet of paper after every print job

check and see if your cursor goes to the next page after your last written one in your document. If so then backspace to your last written page so that the blank page disappears because having this page the computer takes it as part of the document but because there is nothing on it a blank page comes out.
12/1/2013 1:08:03 AM • HP Business... • Answered on Dec 01, 2013
0helpful
3answers

Appearing dots on printer screen

pls check the cartdriges and clean head first. and plug it, power on again your printer. try to print.
11/3/2013 10:12:31 PM • HP Business... • Answered on Nov 03, 2013
0answers
0answers

Turn off error

Be the first to answer 8/26/2013 7:11:41 AM • HP Business... • Posted on Aug 26, 2013Be the first to answer
0helpful
1answer

HP 8500 dumped all the ink out of a new cartridge

That's unusual but was cartridge properly installed? did it give you any warning msgs? if u are going to install new cartridge, check if installation ok. Then using tool menu, clean and then alligne. Do a test print thru start - printer and dvise tab.
8/16/2013 3:28:26 AM • HP Business... • Answered on Aug 16, 2013
0answers
0helpful
3answers

Hp Business Inkjet 2800 printer

Hi

Did you check the connections in the carriage if there is little amount of ink on the contacts? if not then clean it well with a dump cloth and try to re-install the old printhead it will sure accept it. If not then the other way is to change system date of the printer first and then try again.

DO RATE MY SOLUTION
4/6/2013 8:39:11 AM • HP Business... • Answered on Apr 06, 2013
0helpful
1answer

Close covers, but it is closed

1 SWITCH PROBLEM 2 MAIN PWB TO SWITCH WAYAER DICONCT
1/11/2013 11:59:31 AM • HP Business... • Answered on Jan 11, 2013
0helpful
1answer

Service manual for hp business 2800

Go to the following websites for the manual:http://www8.hp.com/us/en/support-drivers.html?jumpid=ex_r11400_us/en//IPG/_ps_g_hpprinterservice/PrinterService&k_clickid=AMS'13'49712'4337041d-9473-c108-33b0-0000742c0cffor

h20000.www2.hp.com/bizsupport/TechSupport/DocumentIndex.jsp?lang=en&cc=us&c...

1/11/2013 11:17:54 AM • HP Business... • Answered on Jan 11, 2013
Not finding what you are looking for?
HP Business InkJet 2800 Printer Logo

179 questions posted

Ask a Question

Usually answered in minutes!

Top HP Office Equipment & Supplies Experts

Cindy Wells

Level 3 Expert

6688 Answers

k24674

Level 3 Expert

8093 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Are you a HP Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

InkJet HP

  • InkJet HP

Most Popular Question

hp business inkjet 2800 printer

  • Office Equipment & Supplies
Loading...